![]() |
mustad 34007
slenon wrote:
I'll look around on line and see what I can find, thanks for the steer. bon appétit :-) -- Cut "to the chase" for my email address. |
mustad 34007
If you do some searching on the Web,
you can find chemically sharpenned hooks for the same price or even less than the traditional Mustads. These cheaper hooks are not QUITE as good as Tiemco etc., but IMO they are better than the traditional Mustads. IMO, the "higher" lines of Mustads are every bit as good as any of the Japanese hooks. However, they are just as expensive. Willi I'll look around on line and see what I can find, thanks for the steer. Since time off is regrettably not a problem, and since travel to sal****er flats, at least, is measured in minutes, cost per hook becomes somewhat more of a factor than for those who must allocate time, trouble, and travel to fish the flats. -- Stev Lenon 91B20 '68-'69 Drowning flies to Dark Star http://web.tampabay.rr.com/stevglo/i...age92kword.htm |
mustad 34007
Hooked:
For my money, I prefer the Tiemco's over Mustad because I know a Tiemco will be sharp and I can't see well enough to sharpen every Mustad I take out of the package. That can be a determinant. Even with contacts I've reading glasses in various strengths in several locations. -- Stev Lenon 91B20 '68-'69 Drowning flies to Dark Star http://web.tampabay.rr.com/stevglo/i...age92kword.htm |
mustad 34007
slenon wrote: If you do some searching on the Web, you can find chemically sharpenned hooks for the same price or even less than the traditional Mustads. These cheaper hooks are not QUITE as good as Tiemco etc., but IMO they are better than the traditional Mustads. IMO, the "higher" lines of Mustads are every bit as good as any of the Japanese hooks. However, they are just as expensive. Willi I'll look around on line and see what I can find, thanks for the steer. Since time off is regrettably not a problem, and since travel to sal****er flats, at least, is measured in minutes, cost per hook becomes somewhat more of a factor than for those who must allocate time, trouble, and travel to fish the flats. From what Sierra fisher said about not being able to chemically sharpen stainless hooks, I don't know if the Japanese hooks would be any better than the standard Mustads for salt water. Willi |
mustad 34007
From what Sierra fisher said about not being able to chemically sharpen
stainless hooks, I don't know if the Japanese hooks would be any better than the standard Mustads for salt water. Willi I've got a few 911 S's and some other Japanese hooks that someone gave me. I'll tie some comparison flies and see how they hold up. -- Stev Lenon 91B20 '68-'69 Drowning flies to Dark Star http://web.tampabay.rr.com/stevglo/i...age92kword.htm |
mustad 34007
In article ,
"slenon" wrote: Hooked: Every Tiemco hook I've bought, was by far sharper than any Mustad hook. Buy a pack and compare for yourself. You'll be surprised at what you've been missing. I'm sure that your post is based upon careful observation. I have noted that Tiemco hooks appear to be sharper, too. However, I can afford to tie more flies if I buy Mustad hooks and sharpen them than if I buy Tiemco or the other Japanese lines. I've had no bad experience with Mustad but have had a several Japanese hooks break in use. That, combined with their higher cost per hook keeps me firmly in the Mustad camp despite their limitations. Have you ever tried canadian llama hooks? They are about $4 per 100 and I find little difference between them and tiemco. |
mustad 34007
"Sierra fisher" wrote in message ... I know just enough about hooks to be dangerous. However I also "know" some Chemical sharpening is done by dipping the hooks in an acid bath. Stainless steel is difficult to sharpen, ( very difficult to chemically sharpen, as many stainless steels are of course acid resistant), and, depending on the steel used ( which of course is an alloy), will also not take or hold an edge easily. There are also other problems in tempering stainless steels. When re-sharpening hooks, it is immaterial how they were originally sharpened. This has no effect on the edge they can take. Lastly, the chemical sharpening is usually the last process, the hooks are of course ground sharp beforehand. TL MC |
mustad 34007
On Sun, 23 May 2004, Willi wrote:
From what Sierra fisher said about not being able to chemically sharpen stainless hooks, I don't know if the Japanese hooks would be any better than the standard Mustads for salt water. I like Dai-Ichi x-points for sal****er although they are quite pricey. Mustad signature line are good but not as good. The difference between the premium and *regular* hooks for sal****er use is that the wire thickness is finer and penetrates more easily. Mu |
mustad 34007
Steve Sullivan:
Have you ever tried canadian llama hooks? They are about $4 per 100 and I find little difference between them and tiemco. Haven't tried them. Got a source or two? -- Stev Lenon 91B20 '68-'69 Drowning flies to Dark Star http://web.tampabay.rr.com/stevglo/i...age92kword.htm |
All times are GMT +1. The time now is 08:59 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2006 FishingBanter