![]() |
|
Leaders
Getting lazy(er)with old age (besides my eyes ain't what they use to be) I
quit tying up my own leaders, have gone to the prepackaged ones. In your collective opinion which tapered leader is easiest to take the coil out after having been on the reel for awhile? I know about the stretching part to get the worst of the coils out, but is there one brand that stands out from the pack? Frank Sr. |
Leaders
On 2010-08-02 17:17:01 -0400, Frank Church said:
Getting lazy(er)with old age (besides my eyes ain't what they use to be) I quit tying up my own leaders, have gone to the prepackaged ones. In your collective opinion which tapered leader is easiest to take the coil out after having been on the reel for awhile? I know about the stretching part to get the worst of the coils out, but is there one brand that stands out from the pack? Frank Sr. Oh, no. A leader fight! d;o) Over the years I have tried several brands, usually bummed from a friend stream-side when I didn't have one, as a gifts, or when forced to buy something I normally wouldn't buy. I normally use nothing but Orvis leaders and swear by them. For normal every day fishing, say at the Rapid, I use a 4 or 5x 7 1/2 ft mono and tie on about 18 inches of 5x fluoro. If the reel goes unused for several months, I have little problem getting out the coils. I have used but do not like Rio, Frog Hair, Maxima. H, ymmv Dave |
Leaders
Frank Church wrote:
Getting lazy(er)with old age (besides my eyes ain't what they use to be) I quit tying up my own leaders, have gone to the prepackaged ones. In your collective opinion which tapered leader is easiest to take the coil out after having been on the reel for awhile? I know about the stretching part to get the worst of the coils out, but is there one brand that stands out from the pack? I buy Orvis Super Strong leaders in the 2 packs and build from there. For trout I start building on the 7.5' 3X and for smallie leaders I start with the 6' 0X. I've never had a memory problem with Orvis Super Strong but I have with Rio. -- Ken Fortenberry |
Leaders
On Aug 2, 5:25*pm, Ken Fortenberry
wrote: Frank Church wrote: Getting lazy(er)with old age (besides my eyes ain't what they use to be) I quit tying up my own leaders, have gone to the prepackaged ones. In your collective opinion which tapered leader is easiest to take the coil out after having been on the reel for awhile? I know about the stretching part to get the worst of the coils out, but is there one brand that stands out from the pack? I buy Orvis Super Strong leaders in the 2 packs and build from there. For trout I start building on the 7.5' 3X and for smallie leaders I start with the 6' 0X. I've never had a memory problem with Orvis Super Strong but I have with Rio. -- Ken Fortenberry My favorite is Frogs Hair, but I hear they're going out of business. Frank Reid |
Leaders
Frank Reid © 2010 wrote in
: Thanks for the input guys, I have used Orvis fly lines and like them a whole lot, easy to get the coils out of them too...will give the Orvis leaders a try. Frank Sr. |
Leaders
On Aug 3, 6:58*pm, Frank Church wrote:
Frank Reid © 2010 wrote : Thanks for the input guys, I have used Orvis fly lines and like them a whole lot, easy to get the coils out of them too...will give the Orvis leaders a try. Frank Sr. At the risk of inflaming an old wound, I find that holding any leaders (including the aforementioned Rio slinkys) in hot water (not boiling, but almost) for about 10 seconds, then holding the ends apart until it cools, results in it becoming straight and malleable. And to my experience, with no loss of strength whatsoever. YMMV, and if I know ROFF, it just might. :-) --riverman |
Leaders
On Aug 3, 7:54*pm, Frank Church wrote:
riverman wrote in news:6247abc7-0810-433b-8da5- : On Aug 3, 6:58*pm, Frank Church wrote: Frank Reid © 2010 wrote innews:cb4d3598-79a7- 4c20 : But how handy would that be if aforementioned leader is already attached to the fly line? Or is this dunking in hot water a permanent solution, which doesn't seem likely to me given the propensities of said leaders to coil in the first place... Frank Sr ..who apologizes for any mis-spellings, my new reading glasses are due this week. Yeah, I do it mostly when its attached to the fly line, as my leaders tend to get a coil memory from being spooled. Its not permanent, but the straightening effect lasts for a long time, several hours or more, depending on how cold the water is. Just hold it in hot water (coffee works fine) for about 10 seconds, then gently stretch it as it cools (like, for another 10 seconds or so). It comes out MUCH straighter (and much more easily) than by pulling it between my fingers. If you're concerned about hot it affects the leader, try it on some old leader that you're going to throw away; you'll be very surprised how well it works. And if there is any loss of strength or elasticity, I've never noticed it. ---riverman |
Leaders
On Aug 3, 9:05*am, riverman wrote:
On Aug 3, 7:54*pm, Frank Church wrote: riverman wrote in news:6247abc7-0810-433b-8da5- : On Aug 3, 6:58*pm, Frank Church wrote: Frank Reid © 2010 wrote innews:cb4d3598-79a7- 4c20 : But how handy would that be if aforementioned leader is already attached to the fly line? Or is this dunking in hot water a permanent solution, which doesn't seem likely to me given the propensities of said leaders to coil in the first place... Frank Sr ..who apologizes for any mis-spellings, my new reading glasses are due this week. Yeah, I do it mostly when its attached to the fly line, as my leaders tend to get a coil memory from being spooled. Its not permanent, but the straightening effect lasts for a long time, several hours or more, depending on how cold the water is. Just hold it in hot water (coffee works fine) for about 10 seconds, then gently stretch it as it cools (like, for another 10 seconds or so). It comes out MUCH straighter (and much more easily) than by pulling it between my fingers. If you're concerned about hot it affects the leader, try it on some old leader that you're going to throw away; you'll be very surprised how well it works. And if there is any loss of strength or elasticity, I've never noticed it. ---riverman- Hide quoted text - - Show quoted text - I like the coffee option. French Roast Coil Reliever is standard here on the Left Coast. Ive also heard Sanka works OK. But my question is "what do you think of using, say, a nice cuppa Guatemalan Antigua's JOE, with those unruly RIO coils? How about Zihuatanejo Pea-berry Java Beans collected from ferret poop? Washed and Full City Roast, right? I find that Lattes made from Organic GM CafinusXCanibus cross, Cal/ Davis #23 beans, . . . make my leaders act silly, and a little hungry if you know what I mean. Why? ;+)) Seriously, I never heard of this before, good Winter tactic. Dave |
Leaders
On 2010-08-03 07:30:48 -0400, riverman said:
On Aug 3, 6:58*pm, Frank Church wrote: Frank Reid © 2010 wrote innews:cb4d3598-79a7-4c20 : Thanks for the input guys, I have used Orvis fly lines and like them a whole lot, easy to get the coils out of them too...will give the Orvis leaders a try. Frank Sr. At the risk of inflaming an old wound, I find that holding any leaders (including the aforementioned Rio slinkys) in hot water (not boiling, but almost) for about 10 seconds, then holding the ends apart until it cools, results in it becoming straight and malleable. And to my experience, with no loss of strength whatsoever. YMMV, and if I know ROFF, it just might. :-) --riverman I believe this was suggested by our infamous roffian George Gerhke many years ago. I tried it once and it works, but I have no trouble removing the coils from the Orvis superstrong leaders I normally use. Dave |
All times are GMT +1. The time now is 08:10 PM. |
|
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2006 FishingBanter