Amended reply...

This is "anyone else" .....

a four blade will give you a better hole shot but less top end speed.
Consider SmartTabs ( or any other tab system ) to
get the stern up when taking off. Do a Google search and you will find many
happy owners. I have them on both of my small boats.

re the "hole pattern" If you DO find that they are different...one way to
get around that is to make up a "mounting board". Take a piece of
hardwood...drill it to fit your present hole pattern. Drill the opposite
side of the board to fit your new hole pattern. Countersink the "new holes"
ON THE BACKSIDE OF THE BOARD and put SS T-nuts into the countersunk areas.
Mount the board to the boat using the "old holes" ...............and then
mount the trolling motor to the Mounting board
using the COUNTERSUNK T-NUTS into the "new holes" ON THE BACKSIDE.
RichG TX


RichG manager, Carolina Skiff Owners Group on MSN
http://groups.msn.com/CarolinaSkiffOwners
.

"Charles B. Summers" wrote in message
...
I have a couple of Nitro questions for you, if you don't mind....

1st: I've got a 23p x 13" prop currently on my 90hp motor. I've been
threatening to replace it with a stainless for awhile now. Do you have
any
recommendations? How about a 4-blade? As of now, I'm getting right at
47mph
at 5500rpm. I'm not looking for more speed, nor less than what I've got
now.
But, would like a little more hole shot when I've got a load and a full
livewell.

2nd: I'm finally ready to replace the trolling motor. It came with the
43lb
thrust Motorguide 12v. I've settled on a replacement, but do you know if
the
hole pattern on a Minn Kota Maxxum (70lb/24v) will be the same, or am I
gonna have to drill new ones?

Thanks for your help!

Charles