What a great thread. Thanks to all for input!!!
What is best adhesive to attach foam (hard and flexible) to fly hooks? CA
or other? Any advice to make your recommendation hold up longer?

John

--
Remove FLY to reply
"LouF" wrote in message
...
On Fri, 18 Feb 2005 11:07:38 -0600, "Guy Thornberg"
wrote:

Super glue spill!!! on the kichen p-lam. what solvent to use? lacquer
thinner, acetone, denatured alcohol, WD40, gin?
G
"Guy Thornberg" wrote in message
...
Thanks Lou,
Which are the 3 or 4 highest quality brands?
G

Highest quailty IMNSHO, Loctite or Henkel brands. I work for them so
I'm somewhat biased. In the consumer market(Lowes, Home Depot etc)
probably sold under the Quiktite name in nifty dispensers. You might
also try an industrial distributor for more choices. If you do that
ask for 495 for general purpose, or 454 for a gel. Also 420 is water
thin and will wick into the threads. If they have 380 or 480 try
them..they're black, rubber toughened formulations. They'll also have
the accelerator in either a brush top or spray bottle.

http://www.loctiteproducts.com/produ...y.asp?catID=15

For spills, the absolute best solvent is nitromethane if you can get
it or almost as good, acetone...nail polish remover for real nails.
The stuff for fake nails is ethyl acetate and won't work, neither will
alcohol or toluene.. You'll need a lot if it's a big spill since the
solvents just dissolve the cured ca and spread it around.. for small
drops you can just allow it to cure fully then scrape the glob off
with a razor and then just clean the area with acetone.