Tony @ bassanglersonline wrote:
I've experienced the same problems with the Soft Bait Glue. I found it
to be a fine product but I was pretty frustrated that the bottle
clogged and dried out before it was half-finished. So, with that, I
went to WalMart and picked up some of this stuff:

http://www.loctiteproducts.com/produ...d=115&plid=195

I found it to work every bit as good and it didn't clog... I'm due for
a third bottle soon. It is a lesser volume then the Pro Soft Bait
stuff but so it only runs about $2 - $3. But, I get to use ALL OF IT.

I also like it because it is a gel and it doesn't run all over the place
such as the line guides, boat carpeting and of course my fingers.

Tony
http://www.bassanglersonline.com

"SHRED" wrote in message
news:t3HWd.95918$bu.41000@fed1read06...

I have been using http://www.prosoftbaitglue.com/index.html

But the bottled gelled up on me even though I was very careful in not
contaminating the glue with water, etc.. Three spouts hardened up on me
even though I rigged a pin plug for them. This stuff is expensive.

Is there a more manageable glue for holding and repairing Yamamoto type
and other soft plastics?

TL




Thanks Tony!