Hey guys!

Well, I ground the boat down to the rivets and bare metal once again just
like new almost. I've tested an area with the bed liner material and it
seems to bond fairly well. Before I put the coat over the whole thing, I
need to look to see if a primer might be necessary. If not, it will be full
steam ahead with this project using bed liner. After hours of research, and
for as many little leaks that I have, this seems to be a viable solution for
this boat. Hopefully one gallon will do the job for the coating, we'll see
how it goes!

I will keep you guys updated whether either good or bad outcome.... I
should snap some before and after pictures and post up if you guys think it
might help others or if your curious yourselves??

I do however really appreciate all the input from you guys... I usually
just kind of browse and sneak around in here and read the posts, and I enjoy
reading what everyone has to say on about every subject.

Thanks everyone and ya know, spawn is right around the corner!!

Doug


"Doug" wrote in message
news:aFe1e.17978$wL6.8199@trnddc03...
Hey guys,

I've got this old Aluminum boat and I'm trying to fix the small leaks and
cracks but their several. Is there a product that any of you know of that
I can just brush or roll on the bottom of the boat to seal it up? I
thought about having it Rhino Lined but that's a little more money than I
want to spend. They told me it would around 250 or so and the boats old
enough, it wouldn't be worth it I think.

Any ideas or suggestions would be appreciated.

Doug