Yeah, I'm going to have to figure out something Bob, I'm getting tired of
spending $20 a week AFTER I get to the lake and discover it or their missing
and can't put in cause I have exposed bearings! Off to the nearest marina I
go...... The whole setup is pretty much a beater and a work in progress.. I
don't know if you remember, but I was the one doing the truck bed liner on
the boat... Which I finished by the way, I think you at one time said you
were curious of the outcome. I works great, sealed great, but definitely
need the primer before putting it on. As far as the speed issue we
discussed, I put my 30 horse Johnson on it instead of my 15 Merc. With my
30 horse, before the lining, I could get 28 MPH, now WITH, I get 22 MPH,
pretty drastic, and unexpected outcome. With the 15 Merc, Pre-liner, I
would get 9 MPH and struggle to get on plane, if it EVER happened. (Pushing
water mostly) Scary to think what I would get now WITH the liner with the
15!!

These speeds are from my GPS BTW, Garmin Etrex Vista.

Anyway, the drilling and tapping is not a problem and a hell of an idea!
But more work then I'd like to put into this relic. Still open to other
options and advice. But that might be the way to go to be sure. I plan on
taking her for a 1000 trip here pretty soon so we'll have to do something!

Thanx Bob and tight lines!

Doug



"Bob La Londe" wrote in message
...

"Doug" wrote in message
news:_u9ke.8133$Rp1.2559@trnddc08...
What's a good way to keep Bearing Buddies from coming off in transit...
Lately, since the bearing switch, I can't seem to keep these dang things
on
securely! Is there a trick to keep them from flying off while going down
the road?? This is my 3rd one in 3 weeks! I don't think locktight will
work since there's so much grease on the inside of the hub, and I'm just
not
sure what to do. Probably a simple solution, but nothing is coming to me
at
the time!

TIA,

Doug



I have heard that some people drill and tap the sides of the hub and put
set
screws in. Not sure how comfortable I would be with that, but it sounds
like it would work. If its an old beater trailer I suppose you could
simpley wrap the sides of the hub and bearing buddy with tape.

As to the idea of locktite.... Even if you cleaned the surfaces you would
have to use the green loctite which is a bushing and sleave locker.

JMHO
Bob La Londe
www.YumaBassMan.com