Oh yeah, I knew what he meant, I would make it look "official" and use an
alan set screw. Thanx for the reply too, peciate it!

Doug


"Todd Copeland" wrote in message
ink.net...
"Doug" wrote in message
news:3mbke.2555$yO1.800@trnddc05...

Anyway, the drilling and tapping is not a problem and a hell of an
idea!

Perhaps what Bob was talknig about but I'd try a very small bolt. Drill
through the hub only, insert the bearing buddy, and then screw the bolt
into the side of the hub through the hole. I'd not apply too much
pressure.
I point out the bolt as opposed to an actual screw.