try this Anthony,
Go out and buy yourself one of those great big spikes that you see at home
depo. Cut both ends off.with a hack saw.. Polish the shaft with a buffer
wheel tap a small screw hole in one end. thread the screw through 2
inverted faucet washers and into the shaft. slide the shaft into an old vice
c-clamp and presto! mount it 12-18" away from your vise and you're in!
"A Comulada" wrote in message
news
I've been looking to get one of those bobbin hangers for my vice. Being
that my vice is one of the bottom of the line, el cheap-o ones from Bass
Pro Shops. I decided to figure out an alternative to use till I can get
the funds for a respectable one that would be included with the vice...

here goes!

I found that a wire-style clothes hanger cut to proper length (12-14"),
making the necessary bends to be able to hold the bobbin out of the way
and
the other end wrapped 3-4 times around the shaft of the vice works great
and at almost no cost (cost of the hanger)... It takes a little effort to
get the right size of the coils. Wrapped a little smaller than the shaft
diameter is ideal (this is the most difficult part). After getting the
coils slid onto the vice shaft and into place, it stays put and doesn't
slide down at all. I'll post a picture on A.B.F.P, sorry for the low-res
pic.

It's not as pretty and clean as a commercial made one but it works for
what I
need it to do...

Anthony