Lindsay,

The floor is complete with new stringers, a underfloor 120L fuel tank,
underfloor drainage pipes from the forward storage pockets and
underfloor electrical conduit. I also made a mould up for some new
fibreglass side pockets. The transom main section is also complete as
well. I am in the process of making a mould to finish of the top
section of the hull where the original outboard well once was. When
this is all done then I have to apply the flow coat to the inside to
finish the job off.

Regards
Bruce


Lindsay wrote in message ...
bruce wrote:

I know this has nothing to do with sport fishing directly, but I have
tried just about every other news group that exists.

So here goes, I am looking for anyone who owns or has owned a
"Swiftcraft Dominator".
In particular I am interested in talking to anyone who's "Swiftcraft
Dominator" outboard or stern drive hulls have been converted to use an
outboard pod design.

How'd ya go with the floor?

Lindsay