Larry L wrote:
"Mike Connor" wrote
The modifications are quite simple as well. I use a needle knotted
butt section directly on my line, if necessary with two or more
sections, to obtain the diameter and taper I require, as the
knotless leader butt sections are usually of too small a diameter.
I use a leader ring at the end of the knotless leader, as I can then
change tippet, or droppers etc etc, with no fuss and bother, without
shortening or otherwise damaging the leader, and very quickly, and
without wasting nylon. This is also much more
flexible in use than knotted leaders.
Mike, a couple questions/ comments
I'm currently using mainly a section or two of maxima, as butt, tied
to a tapered leader with it's butt removed ... I like stiffer butts
than what I find on tapered leaders ... this sounds very much like
your, " if necessary with two or more sections, to
obtain the diameter and taper I require, as the knotless leader butt
sections are usually of too small a diameter" ... is it" or am I
reading your post incorrectly? If correct, then you are really
using a kind of 1/2 hand tied leader, like myself, right?
Second ... the phrase "leader ring" is entirely new to me ..... what
is this in American english ? g
In the previous, much diverted, loop thread I said I use loops, and I
do not out of loopophilia, rather ... mainly because its the BUTT
not the tippet that I feel the need to change to match different
techniques and conditions. Again this sounds much like your, "With
three knotless tapered leaders in different configurations, suitably
modified, I can use practically any standard technique, and a few
more besides " Are these three mainly BUTT differences?
After reading your post, i realized the main feature I like better about
hand tied leaders - the stiffer butt section. I've never tried it the
way Mike describes it, but my guess is that I would like the tapered
leader with butt section removed tied onto the stiffer butt section of
Maxima Chameleon (I sometimes use 30 pound / .022 inch, but usually 25
pound / .020 inch). It's just that the blood knot machine is soooooo
much fun, I can't stop! ;-)
--
TL,
Tim
------------------------
http://css.sbcma.com/timj