Thread
:
splitting tails
View Single Post
#
4
January 2nd, 2004, 10:19 PM
Norman Greenwood
external usenet poster
Posts: n/a
splitting tails
one turn through the "V" down, one turn through the "v" up, then one
turn under the tails to raise them as desired.
One locking turn,then dub the boddy
--
A Yorkshire Lad
Remove spam filter to reply
Uncle Mac wrote in message
k.net...
Al Beatty uses a small piece of tying thread to split the tails and
then
wrap back over the body before final dubbing. Double the thread, hook
it
around the gape, and pull over body, splitting the tail evenly.
Tighten the
thread loop to spread and/or raise tail before wrapping.
"Larry L" wrote in message
news
I want to widely split the tails on small sized spinner patterns
WITHOUT
using a "small ball of dubbing"
OR, going nuts from frustrationg,
I bet one or more of you guys has a great method to share?
PS I can use either hackle barbs or microfibit tails
Norman Greenwood