As I recall the shaft on the 624 is integral with the spool so without
specialist tools it would be difficult to replace one without the other,
even then it would not be easy.

Most probable cause is that the clutch has either been put together
incorrectly, or the clutch plates have been contaminated with oil or
grease.

On Sun, 03 Jun 2007 12:35:49 +0100, Fantom
wrote:


Tight Lines.

Chris.

Hi,
I recently got my mitchell 624 reel serviced and it needed a
replacement
shaft, which was done.

I have been using it since but the spool seems to slip like mad...It's
like
the reel is just giving up. The clutch seems to have no play in it.

Any ideas, and its defo not the line slipping.

TIA






--