![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I went to the Bass Pro Shop in Myrtle Beach this week to buy a baitcast
reel. The reel I went to get was all sold out except the display one. I hate to buy the display because they have been handled so much. The sales person behind the counter showed me another reel that he claimed was the same reel but it cost $30.00 less. I asked him if it was the same reel why did it cost $30.00 less? He showed me a small oil port on the bottom of the more expensive reel and he declared the only difference between the two reels was the oil port. He said you are paying $30.00 extra for the convenience of that oil fitting. They were the same brand and they did look exactly alike. So I bought two of the cheaper reels with matching rods. I then went over to the fishing line isle. Once again they were sold out of what I wanted, 10 lb Fluorocarbon line. They had only one spool of the 10 lb and I needed two. So I bought one spool of 10 lb Fluorocarbon and one spool 10 lb Monofilament. I have never fished with Fluorocarbon. I wanted to try it because a friend of mind who knows far more about Bass fishing than I do, thinks that Fluorocarbon is the greatest line ever. When I got home I filled one reel with Fluorocarbon and the other reel with Monofilament. I then attached a 3/8 oz practice plug to each rod and went out into the yard to try out my new rods. I adjusted both reels as close as I possibly could to be the same. I did not count how many cast I made but it was a lot. Using identical brand new rods and reels I discovered that the Fluorocarbon would cast from 15 to 20 yards further than the Monofilament on every cast. Has anyone else experienced Fluorocarbon casting better than Monofilament? James |
#2
|
|||
|
|||
![]()
Another issue is that of line stretch. Mono stretches a lot more then Flouro. Personally, I use Silver Threat Excalibur, which is a copolymer for my baitcasters, and 20 lb Power Pro on my spinning reels. When I'm fishing really clear water, I change spools to to 10 lb Excalibur.
"James" wrote in message ... I went to the Bass Pro Shop in Myrtle Beach this week to buy a baitcast reel. The reel I went to get was all sold out except the display one. I hate to buy the display because they have been handled so much. The sales person behind the counter showed me another reel that he claimed was the same reel but it cost $30.00 less. I asked him if it was the same reel why did it cost $30.00 less? He showed me a small oil port on the bottom of the more expensive reel and he declared the only difference between the two reels was the oil port. He said you are paying $30.00 extra for the convenience of that oil fitting. They were the same brand and they did look exactly alike. So I bought two of the cheaper reels with matching rods. I then went over to the fishing line isle. Once again they were sold out of what I wanted, 10 lb Fluorocarbon line. They had only one spool of the 10 lb and I needed two. So I bought one spool of 10 lb Fluorocarbon and one spool 10 lb Monofilament. I have never fished with Fluorocarbon. I wanted to try it because a friend of mind who knows far more about Bass fishing than I do, thinks that Fluorocarbon is the greatest line ever. When I got home I filled one reel with Fluorocarbon and the other reel with Monofilament. I then attached a 3/8 oz practice plug to each rod and went out into the yard to try out my new rods. I adjusted both reels as close as I possibly could to be the same. I did not count how many cast I made but it was a lot. Using identical brand new rods and reels I discovered that the Fluorocarbon would cast from 15 to 20 yards further than the Monofilament on every cast. Has anyone else experienced Fluorocarbon casting better than Monofilament? James |
#3
|
|||
|
|||
![]()
I have always used mono on my spinning reels but after a seminar at
Sportsman's Wharehouse suggested using Fireline for bass and crappie I decided to give it a try and after loading it on my Mitchell 300 I found a decided improvement in casting distance with no other changes . Not a totally scientific result but it does seem to show that on that reel the Fireline did cast better than mono . "James" wrote in message ... I went to the Bass Pro Shop in Myrtle Beach this week to buy a baitcast reel. The reel I went to get was all sold out except the display one. I hate to buy the display because they have been handled so much. The sales person behind the counter showed me another reel that he claimed was the same reel but it cost $30.00 less. I asked him if it was the same reel why did it cost $30.00 less? He showed me a small oil port on the bottom of the more expensive reel and he declared the only difference between the two reels was the oil port. He said you are paying $30.00 extra for the convenience of that oil fitting. They were the same brand and they did look exactly alike. So I bought two of the cheaper reels with matching rods. I then went over to the fishing line isle. Once again they were sold out of what I wanted, 10 lb Fluorocarbon line. They had only one spool of the 10 lb and I needed two. So I bought one spool of 10 lb Fluorocarbon and one spool 10 lb Monofilament. I have never fished with Fluorocarbon. I wanted to try it because a friend of mind who knows far more about Bass fishing than I do, thinks that Fluorocarbon is the greatest line ever. When I got home I filled one reel with Fluorocarbon and the other reel with Monofilament. I then attached a 3/8 oz practice plug to each rod and went out into the yard to try out my new rods. I adjusted both reels as close as I possibly could to be the same. I did not count how many cast I made but it was a lot. Using identical brand new rods and reels I discovered that the Fluorocarbon would cast from 15 to 20 yards further than the Monofilament on every cast. Has anyone else experienced Fluorocarbon casting better than Monofilament? James |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fluorocarbon leaders, anyone use them? | Tom Nakashima | Fly Fishing | 53 | January 29th, 2006 02:40 AM |
Fluorocarbon and copolymer lines for sale...... | schreecher | Bass Fishing | 0 | November 13th, 2003 04:20 AM |