![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() Hook: TMC100 #8 (wide gap dry fly) Wing Case: 2 mm 1/4” w x 1” long Hobby Lobby Foam. (Pointed on tie in end) Body Chenille Medium Chartreuse or Black Bead: Plastic, copper or gold as small as possible to slide over hook Approximately .10 od (Available at Hobby Lobby) Sequin: Gold or Silver approximately. .30 od (Available at Hobby Lobby) Legs: Rubber, Silly legs, Kush Ball material Tail: Black Bear or Synthetic Duster material Eyes; Optional mono eyes large size Thread: # 8 uni Glue: Fishing Glue (Note thin bristles in brush by 50%) Tying the Popper 1. Start by smashing the barb if you desire. (I do all mine). 2. Slip on bead and Sequin bent 90* on the hook facing forward 3. Secure hook in vise and wrap thread from the eye back about ¼ “. and back forward again as much as necessary to obtain a snug fit of bead and the sequin. Whip finish or half hitch and cut thread 4. Slide bead forward along with sequin to eye of hook. 5Tie the thread in behind the sequin forming a cone to secure the sequin against the bead, then continue to wrap to the rear of hook above the barb. 6. Check for proper alignment of the sequin and apply a drop of fishing glue to the back of the sequin on the thread. 7. Tie in tail material (hook gap long) and tie down the entire length of hook. 8. Wrap back to the hook barb and tie in pointed end of the 2 mm foam and the chenille Note: I recommend tying the foam on the side and let it roll over as you wrap it down 9. Check alignment. Apply a drop of glue to secure position of foam Then continue the thread forward to center of hook and tie in legs and continuing wrap to the rear of sequin. 10. Wrap the chenille forward while positioning legs tying chenille in behind the sequin. Tie in optional eyes on top of chenille Fold foam to the front tying off and whip finish behind the sequin and in front of the eyes. Apply glue to back of sequin to secure foam in position and apply a drop to the threads of the whip finish Cut foam off approximately 1/16 longer than sequin Enjoy and catch some fish Larry....... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
sequine popper | Larry and a Cat named Dub | Fly Fishing Tying | 6 | January 21st, 2007 08:31 AM |
Larry hits the big time? | salmobytes | Fly Fishing | 4 | January 7th, 2007 01:09 PM |
Larry hits the big time? | salmobytes | Fly Fishing Tying | 4 | January 7th, 2007 01:09 PM |
Rainey's Popper Paint | John | Fly Fishing Tying | 0 | February 19th, 2005 07:51 AM |
bass popper | Gone Angling | Bass Fishing | 2 | November 13th, 2003 05:44 AM |