|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 11th, 2007, 05:32 PM
posted to rec.outdoors.fishing.bass
|
|||
|
|||
Flush-mounted TM Pedal
I just got my Lowe bass boat and it appears to have a "pre-made" place
for my pedal to be flushmouted! The opening is 8.5" x 10.5". The pedal will fit. I will need to remove the lid and deep plastic tray. They are riveted on to the aluminum deck. Is there any easy way to remove rivets? Is the center a good place for the pedal control?...I am a noobie  .Pic: http://img.photobucket.com/albums/v4...20160W/bow.jpg Who sells the trays that set into an opening like this? Thanks 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1989 Ford F-150 XLT Lariat towing capacity of Bumper mounted ball | [email protected] | Saltwater Fishing | 0 | May 26th, 2006 11:55 PM |
| Recessed Trolling motor pedal | Joshuall | Bass Fishing | 18 | September 7th, 2004 02:12 AM |
| ot converting bow mounted trolling motor | luv2bafield | Bass Fishing | 22 | January 9th, 2004 06:55 PM |
| bow mounted electric trolling motor | phil caruso | Bass Fishing | 5 | October 21st, 2003 01:21 PM |
Threaded Mode