|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 11th, 2004, 05:52 AM
|
|||
|
|||
bedliner on fiberglass
Have any of you used roll on bed liner to finish the floor of a fiberglass
boat. I'm looking for an easy to clean durable surface for the inside of my small fiberglass fishing boat. Any suggestions will be appreciated. Thanks, 
|
|
#2
March 11th, 2004, 09:18 PM
|
|||
|
|||
|
bedliner on fiberglass
It's slick when wet---------could add sand/grit-------not as tough as the
sprayed on material--all I know. "DAVID MC CARVER" wrote in message ... Have any of you used roll on bed liner to finish the floor of a fiberglass boat. I'm looking for an easy to clean durable surface for the inside of my small fiberglass fishing boat. Any suggestions will be appreciated. Thanks,
|
|
#3
March 12th, 2004, 01:41 PM
|
|||
|
|||
|
bedliner on fiberglass
"DAVID MC CARVER" wrote in message ... Have any of you used roll on bed liner to finish the floor of a fiberglass boat. I'm looking for an easy to clean durable surface for the inside of my small fiberglass fishing boat. Any suggestions will be appreciated. Thanks, I used the roll on bedliner in my truck and it works fine. I would assume that it would work as well in a boat. -- Steve @ OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS 17' Yar-Craft fiberglass bow rider, 120hp Mercrusier I/O, cracked block. Needs repair | Dan S | General Discussion | 0 | May 7th, 2004 03:40 PM |
| fiberglass rods? | Mu Young Lee | Fly Fishing | 37 | October 14th, 2003 01:50 AM |
Linear Mode
