![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
So folks
What are the benifits in the different hook types. ie. Spade end v's Eyed. I'm tying a tucked Half Blood Knot on my eyed hooks and the spade end knot as per this site http://www.floatsgone.btinternet.co....adeendknot.htm It doesnt specify how many times that you have to go around the hook, I have tried between 5 and 10 with the knot becoming less secure the more turns there are.... I personally have found the tucked half blood both easier to tie and more secure. One out of every three of my spade knots just slips off of the top of the hook.. So are there any benifits to either hook type, or are there different knots that I should be trying, or am I doing it way wrong. |
#2
|
|||
|
|||
![]()
Tench Ninja wrote:
: So folks : : What are the benifits in the different hook types. ie. Spade end v's : Eyed. : : I'm tying a tucked Half Blood Knot on my eyed hooks and the spade end : knot as per this site : http://www.floatsgone.btinternet.co....adeendknot.htm : It doesnt specify how many times that you have to go around the hook, : I have tried between 5 and 10 with the knot becoming less secure the : more turns there are.... : : I personally have found the tucked half blood both easier to tie and : more secure. One out of every three of my spade knots just slips off : of the top of the hook.. : : So are there any benifits to either hook type, or are there different : knots that I should be trying, or am I doing it way wrong. Once you've made the loop and are lashing it around the flank you should give it about six turns, then pull the loose end through the loop as tightly as you can, i generally use a pair of forceps and find that I can usually tighten it by about 4mm of line....snip the loose end off a few mm from the knot. Spades are better than eyed because they hang better from the line, eyed ones always seem to be at a weird angle from the end of the line. BTW....As shown on that site, if you make the loop quite large and hold the loop and the bend of the hook together with thumb and forefinger, it leaves your other hand free to lash the loose end around the shank, just make sure there's a bit of tension on the line leading to the reel. HTH |
#3
|
|||
|
|||
![]() "Phil L" wrote in message news:eITcc.4758$lh3.45579367@news- Spades are better than eyed because they hang better from the line, eyed ones always seem to be at a weird angle from the end of the line. -------------------------------------------- I normally bend the eye back and treat it as a spade, (dont thread the line through it) then tye the hook on as I would a spade. they hang straight that way. |
#4
|
|||
|
|||
![]()
In article , Tench Ninja
wrote: So folks What are the benifits in the different hook types. ie. Spade end v's Eyed. Pretty much of a muchness. Spades make for a neater knot (but you can use the same knot on an eyed hook if you like) and eyed hooks are easier to tie in the dark or with very cold hands.. Worms are damaged less by a spade and big paste/bread baits stay better on an eye. I'm tying a tucked Half Blood Knot on my eyed hooks and the spade end knot as per this site http://www.floatsgone.btinternet.co....adeendknot.htm It doesnt specify how many times that you have to go around the hook, I have tried between 5 and 10 with the knot becoming less secure the more turns there are.... Sounds like you are using a relatively thick, springy line. Try something thinner. I tend to tie spades the other way up btw - whipping away from the spade but the knot shown should be secure as long as you control it well when tightening it. I personally have found the tucked half blood both easier to tie and more secure. One out of every three of my spade knots just slips off of the top of the hook.. So are there any benifits to either hook type, or are there different knots that I should be trying, or am I doing it way wrong. Find something that suits you and stick with if for a while. It really doesn't make all that much difference. Come back and try again when you feel ready. Cheerio, -- |
#5
|
|||
|
|||
![]()
In article , Alex
wrote: "Phil L" wrote in message news:eITcc.4758$lh3.45579367@news- Spades are better than eyed because they hang better from the line, eyed ones always seem to be at a weird angle from the end of the line. -------------------------------------------- I normally bend the eye back and treat it as a spade, (dont thread the line through it) then tye the hook on as I would a spade. they hang straight that way. I thread through and then tie as a spade. Each to their own. Cheerio, -- |
#6
|
|||
|
|||
![]() "Tench Ninja" wrote in message ... So folks What are the benifits in the different hook types. ie. Spade end v's Eyed. Spades give better presentation at smaller hook sizes 16+. Eyed small hooks tend to have the hole much too big in relation to the hook, and therefore poor presentation. I always use a hooktyer for spades on the odd occasion I use smaller hooks. It does the job so much better than the human eye can, and only costs a couple of quid. Eyed are better for anything bigger as you tend to use a higher diameter line which doesn't whip so well IMHO.. Also a hair rig on a spade would be incredibly fiddly to knock up on the bank. Blakey --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.654 / Virus Database: 419 - Release Date: 06/04/2004 |
#7
|
|||
|
|||
![]()
Good Question with many answers, as personal preference tends to rule.
I use a hooktier and put 6 turns in away from the spade. I get perfect strong knots every time (unless I rush!). I nearly always use eyed hooks for sizes over 10s |
#8
|
|||
|
|||
![]() "Derek.Moody" wrote in message ... In article , Tench Ninja wrote: eyed hooks are easier to tie in the dark or with very cold hands.. ----------------------------------------------------------------- ---- I will admit that for anything below (10) I tend to use the ready tied. Joined onto the main line with a loop, like a fly leader. |
#9
|
|||
|
|||
![]()
:Sounds like you are using a relatively thick, springy line. Try something
:thinner. I tend to tie spades the other way up btw - whipping away from the :spade but the knot shown should be secure as long as you control it well :when tightening it. I was using 5lb Maxima chameleon Mono (which is 0.20mm dia), was only for practice while I was learning the knot. I'm now getting on fairly well with 3lb of same. which is 0.15mm dia. I'm also using a little knot tying tool I picked up today called a haakaanbinder made by a company called Albatros link: http://www.visserslatijn.nl/techniek...matchman.shtml This makes it much easier and quicker to get the knot done. The whole whipping away from the spade is confusing me.. Does it provide a more secure knot? And is it simply a matter of starting the knot as normal, but start the whipping at the spade and work down the shank from there, resulting in the line doubled under the whipping.. If you get me? Thanks for all the feedback so far folks. /T Ninja (AKA Daniel) |
#10
|
|||
|
|||
![]()
On Thu, 8 Apr 2004 08:26:32 +0000 (UTC), "Simondo"
wrote: Good Question with many answers, as personal preference tends to rule. I use a hooktier and put 6 turns in away from the spade. I get perfect strong knots every time (unless I rush!). I nearly always use eyed hooks for sizes over 10s By over 10 i assume you mean bigger hooks not bigger numbers ie size 6 not size 16 |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fishing Hooks | Bill Kiene | Fly Fishing | 23 | June 30th, 2011 01:24 AM |
Magnetic hooks | vincent p. norris | Fly Fishing Tying | 11 | March 18th, 2004 06:40 AM |
Hooks for newbie | Reed Waters | Fly Fishing Tying | 53 | February 23rd, 2004 02:33 AM |
Gamakatsu Fly Tying Hooks - Opinion | Cornmuse | Fly Fishing Tying | 3 | February 20th, 2004 04:08 AM |
Deep Hooked Pike | Danny | UK Coarse Fishing | 6 | November 8th, 2003 10:01 AM |