Anti reverse AND direct drive?

Anti reverse reels are known to be heavy, unreliable because they have too
many small delicate moving parts, it is hard to tell if the line is coming
in or going out while you are cranking and you waist energy winding against
the drag. whereas direct drive reels can beat up your knuckles and snap the
tippet if you do not pay attention.

Marryat has developed a new generation anti reverse/direct drive fly reel
which progressively adds drag when you squeeze the handle; enough to lock it
making the switch from anti reverse to direct drive, allowing you to pump
the rod and retrieve line. As soon as you release the fingertip pressure the
drag automatically goes back to the initial setting which is usually set
fairly low ready for the strike. Your hand always remains on the handle and
you instinctively control this reel with the tip of you fingers.

This "Swiss Made" fly reel is built with the minimum amount of parts making
it highly reliable and very lightweight.

I would be glad to answer any questions.

Marryat,

Roger Ritter
Inventor of the Marryat Plus


For more information: www.marryat.com



----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----

"Roger Ritter" wrote in message
...
Anti reverse reels are known to be heavy, unreliable because they have too
many small delicate moving parts, it is hard to tell if the line is coming
in or going out while you are cranking and you waist energy winding
against the drag. whereas direct drive reels can beat up your knuckles and
snap the tippet if you do not pay attention.

Marryat has developed a new generation anti reverse/direct drive fly reel
which progressively adds drag when you squeeze the handle; enough to lock
it making the switch from anti reverse to direct drive, allowing you to
pump the rod and retrieve line. As soon as you release the fingertip
pressure the drag automatically goes back to the initial setting which is
usually set fairly low ready for the strike. Your hand always remains on
the handle and you instinctively control this reel with the tip of you
fingers.

This "Swiss Made" fly reel is built with the minimum amount of parts
making it highly reliable and very lightweight.

I would be glad to answer any questions.

Marryat,

Roger Ritter
Inventor of the Marryat Plus


If your reel is as good as your statements, it is crap. Anti reverse reels
require one bearing is all to generate the anti-reverse. A bearing type
that has been made for years and acts like a clutch.

Hi Calif,

It takes a little more than just one roller clutch bearing to make a
reliable anti reverse reel, but I agree with you that there are anti reverse
reels in this market that are very reliable, but people who are used to fish
with DD reels somehow think that the extra AR mechanism gives a higher risk
for failure. This is not the main point.

The biggest disadvantage of an AR reel is that line can go off the reel
while you are reeling in and you constantly have to adjust the drag in a
time when you need to concentrate in front where the action is. People like
to pre adjust the drag only once per day. With the Marryat Plus you can
decide if you want to remain in anti reverse mode or you squeeze the handle
to put it in DD mode and pump the rod and retrieve the line. This is
definitely an advantage towards a standard AR reel.

Marryat,

Roger Ritter
Inventor of the Marryat Plus


For more information: www.marryat.com



"Calif Bill" wrote:

If your reel is as good as your statements, it is crap. Anti reverse
reels require one bearing is all to generate the anti-reverse. A bearing
type that has been made for years and acts like a clutch.

"Roger Ritter" wrote in message
...
Anti reverse reels are known to be heavy, unreliable because they have
too many small delicate moving parts, it is hard to tell if the line is
coming in or going out while you are cranking and you waist energy
winding against the drag. whereas direct drive reels can beat up your
knuckles and snap the tippet if you do not pay attention.

Marryat has developed a new generation anti reverse/direct drive fly reel
which progressively adds drag when you squeeze the handle; enough to lock
it making the switch from anti reverse to direct drive, allowing you to
pump the rod and retrieve line. As soon as you release the fingertip
pressure the drag automatically goes back to the initial setting which is
usually set fairly low ready for the strike. Your hand always remains on
the handle and you instinctively control this reel with the tip of you
fingers.

This "Swiss Made" fly reel is built with the minimum amount of parts
making it highly reliable and very lightweight.

I would be glad to answer any questions.

Marryat,

Roger Ritter
Inventor of the Marryat Plus





----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----

Okay, I'll "bite." At the end of the month, I will be moving to an
area of the US more known for carp than trout. When I lived there
last, I looked for, but could not find, an affordable quality
anti-reverse, multiplier fly reel. Carp are notorious for huge runs
right at you and then a quick turn to the side, hence the desire for
the above mentioned real.
Questions: Does this reel come in a multiplier form? If you fight a
fish from the reel, the multiplier format would be to your advantage.
Anti-reverse and multiplier would seem to be the optimal marriage.
How does the anti-reverse set up work with fine tippets? I am familiar
with anti-reverse reels in a baitcaster format. When using an
anti-reverse baitcaster I would normally put on a higher breaking
strength line. With this "graduated" anti-reverse, is there a setting
that would ensure you do not put on so much pressure that your would
break your tippet? If its just "feel" then I could imagine a lot of
break offs due to the extra adrenaline imparted by a big fish.
Thanks in advance. Would like to give this system a test run on some
of the big carp in Omaha.
Frank Reid

On Tue, 7 Feb 2006 12:44:48 +0100, "Roger Ritter"
wrote:

Hi Calif,

It takes a little more than just one roller clutch bearing to make a
reliable anti reverse reel, but I agree with you that there are anti reverse
reels in this market that are very reliable, but people who are used to fish
with DD reels somehow think that the extra AR mechanism gives a higher risk
for failure. This is not the main point.

The biggest disadvantage of an AR reel is that line can go off the reel
while you are reeling in and you constantly have to adjust the drag in a
time when you need to concentrate in front where the action is. People like
to pre adjust the drag only once per day. With the Marryat Plus you can
decide if you want to remain in anti reverse mode or you squeeze the handle
to put it in DD mode and pump the rod and retrieve the line. This is
definitely an advantage towards a standard AR reel.

Marryat,

Roger Ritter
Inventor of the Marryat Plus


For more information: www.marryat.com



In my opinion, you're not quite spamming, because it was one
well-identified announcement-type thing and you had the courtesy to
follow the thread and reply in a timely manner, but I'll refrain from
just taking your word for things. If you really wish to participate
around here, welcome aboard, but you may just wish to sell us ****
(unlike the other "vendors" around here).

So, here's my proposal: If you really want those here on ROFF to become
familiar with, and potentially buy your reel, prove that it and you are
something worthy of consideration. I'd trust a review from Frank Reid,
as I think many, if not most, here would. He expressed an interest, so
send him one and let him review it (his returning or keeping it is
betwixt the two of y'all). If he gives it a thumbs-up, I suspect it'll
garner a lot more positive attention here. Of course, if he rips it and
you whine...

And for the record, I have no interest whatsoever in your sending Frank
in particular a demo.

HTH,
R

"Roger Ritter" wrote in message
...
Anti reverse reels are known to be heavy, unreliable because they have too
many small delicate moving parts, it is hard to tell if the line is coming
in or going out while you are cranking and you waist energy winding
against the drag. whereas direct drive reels can beat up your knuckles and
snap the tippet if you do not pay attention.

Marryat has developed a new generation anti reverse/direct drive fly reel
which progressively adds drag when you squeeze the handle; enough to lock
it making the switch from anti reverse to direct drive, allowing you to
pump the rod and retrieve line. As soon as you release the fingertip
pressure the drag automatically goes back to the initial setting which is
usually set fairly low ready for the strike. Your hand always remains on
the handle and you instinctively control this reel with the tip of you
fingers.

This "Swiss Made" fly reel is built with the minimum amount of parts
making it highly reliable and very lightweight.

I would be glad to answer any questions.

Marryat,

Roger Ritter
Inventor of the Marryat Plus


For more information: www.marryat.com
----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet
News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+
Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption
=----


I wouldn't mind trying your "anti reverse and direct drive reel". I will
be fishing for king salmon in Alaska this July with a 10 wt 9' fly rod.
What's involved in getting onto your test-drive list? I'm actually in the
market for a 10 wt.fly- reel as I have posted in this newsgroup earlier.
You can email me direct if you'd like:

thanks,
-tom

Hmm, interesting proposal. Though I rarely hear my name and trust in
the same sentence when referring to fly fishing. "Frank, I'll trust
you to show me where its safe to wade." "Frank, I'll trust you to
guide me down this steep hill to the creek." Nah, that just doesn't
sound right.
In all honesty, I would love to give the system a try. Sufficient eval
period (like the Spring/Summer drop of the cottonwood seeds. Great
time for carp on the surface.) and complete freedom to write what I
feel.
This forum has a lot of readers and a lot of impact. In the past, I've
read some stats that say that there are as many as 2000-5000 folks
lurking in a week. I know that I often google a product in this group
before I buy.
I could only hope that the reel is of the same quality as the Marryat
vise. The best fly tyer I know (Tim Trexlar, double gold medal winner
at the Irish Open fly tying competition) uses one.
And I agree with Messr Dean. Not spam. An inventor, proud of his
product, going to a tough forum to introduce his product and is willing
to answer questions. Pretty much like a lot of the guys here that have
invented a new fly.
Frank Reid

"Frank Reid" wrote in
ups.com:

Hmm, interesting proposal. Though I rarely hear my name and trust in
the same sentence when referring to fly fishing.

Obviously, he meant that if a fishing product can survive through some of
your more interesting outings, it will live through anything!!

--
Scott
Reverse name to reply

On 2/7/06 9:56 AM, in article
, "Scott Seidman"
wrote:

"Frank Reid" wrote in
ups.com:

Hmm, interesting proposal. Though I rarely hear my name and trust in
the same sentence when referring to fly fishing.

Obviously, he meant that if a fishing product can survive through some of
your more interesting outings, it will live through anything!!

Just don't keep it in your tent next to the cooler with the venison.

:-)

Bill

On 7 Feb 2006 06:40:07 -0800, "Frank Reid"
wrote:

Hmm, interesting proposal. Though I rarely hear my name and trust in
the same sentence when referring to fly fishing. "Frank, I'll trust
you to show me where its safe to wade." "Frank, I'll trust you to
guide me down this steep hill to the creek." Nah, that just doesn't
sound right.

Um, well, I didn't say I trusted your ability to remain dry and
undamaged, just your integrity in giving a fair trial and
review...assuming, of course, that you survive the testing phase G.
But heck, it were a personal safety device that needed a tryout, you'd
be the unquestionable "go to" guy - I mean, what could be better than
"insert product name kept Frank Reid upright and free of holes!" as a
safety endorsement...screw the "UL" cert, I want a "FR"...

TC,
R

In all honesty, I would love to give the system a try. Sufficient eval
period (like the Spring/Summer drop of the cottonwood seeds. Great
time for carp on the surface.) and complete freedom to write what I
feel.
This forum has a lot of readers and a lot of impact. In the past, I've
read some stats that say that there are as many as 2000-5000 folks
lurking in a week. I know that I often google a product in this group
before I buy.
I could only hope that the reel is of the same quality as the Marryat
vise. The best fly tyer I know (Tim Trexlar, double gold medal winner
at the Irish Open fly tying competition) uses one.
And I agree with Messr Dean. Not spam. An inventor, proud of his
product, going to a tough forum to introduce his product and is willing
to answer questions. Pretty much like a lot of the guys here that have
invented a new fly.
Frank Reid