|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 19th, 2007, 05:32 AM
posted to rec.outdoors.fishing.saltwater
|
|||
|
|||
trolling motor issue
I have a 24v motorguide great white trolling motor, that I converted
last fall to the digital series. I have an inline auto reset circuit breaker connected to the pos cable near battery. hen I run the motor on med to high the motor cuts out and comes back on in a few seconds. Any ideas? Could I have a bad connection or bad breaker that get too much heat that triggers the breaker? Thanks! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| trolling motor issue | tim3313 | General Discussion | 2 | April 20th, 2007 03:33 AM |
| trolling motor issue | tim3313 | Bass Fishing | 2 | April 19th, 2007 01:47 PM |
| trolling motor issue | tim3313 | Saltwater Fishing | 0 | April 19th, 2007 05:31 AM |
| Motor Guide trolling motor | IBNFSHN | Bass Fishing | 0 | February 16th, 2005 03:59 PM |
Threaded Mode