"Swiftcraft Dominator" hulls

I know this has nothing to do with sport fishing directly, but I have
tried just about every other news group that exists.

So here goes, I am looking for anyone who owns or has owned a
"Swiftcraft Dominator".
In particular I am interested in talking to anyone who's "Swiftcraft
Dominator" outboard or stern drive hulls have been converted to use an
outboard pod design.

Regards
Bruce

bruce wrote:

I know this has nothing to do with sport fishing directly, but I have
tried just about every other news group that exists.

So here goes, I am looking for anyone who owns or has owned a
"Swiftcraft Dominator".
In particular I am interested in talking to anyone who's "Swiftcraft
Dominator" outboard or stern drive hulls have been converted to use an
outboard pod design.

How'd ya go with the floor?

Lindsay
--
Scrap the 00 to post direct.

'Speed limit near schools lowered to 40 grams per student' - CNNNN

Lindsay,

The floor is complete with new stringers, a underfloor 120L fuel tank,
underfloor drainage pipes from the forward storage pockets and
underfloor electrical conduit. I also made a mould up for some new
fibreglass side pockets. The transom main section is also complete as
well. I am in the process of making a mould to finish of the top
section of the hull where the original outboard well once was. When
this is all done then I have to apply the flow coat to the inside to
finish the job off.

Regards
Bruce


Lindsay wrote in message ...
bruce wrote:

I know this has nothing to do with sport fishing directly, but I have
tried just about every other news group that exists.

So here goes, I am looking for anyone who owns or has owned a
"Swiftcraft Dominator".
In particular I am interested in talking to anyone who's "Swiftcraft
Dominator" outboard or stern drive hulls have been converted to use an
outboard pod design.

How'd ya go with the floor?

Lindsay

bruce wrote:

Lindsay,

The floor is complete with new stringers, a underfloor 120L fuel tank,
underfloor drainage pipes from the forward storage pockets and
underfloor electrical conduit. I also made a mould up for some new
fibreglass side pockets. The transom main section is also complete as
well. I am in the process of making a mould to finish of the top
section of the hull where the original outboard well once was. When
this is all done then I have to apply the flow coat to the inside to
finish the job off.

Sounds great!!! Well done!
Did you find any black filler under the stringers/keel?

Got any pics? Gunna upload them to the web somewhere?

Seasons greets to all in aus fishing...

Lindsay

--
Scrap the 00 to post direct.

'Speed limit near schools lowered to 40 grams per student' - CNNNN

Once the top section of the hull where the original outboard well was,
I will post a series of pics up to this stage. This could be a while
as we are also doing some renovations on the family home early in the
new year. But it will happen.

Enjoy your Xmas and tight lines.



Lindsay wrote in message ...
bruce wrote:

Lindsay,

The floor is complete with new stringers, a underfloor 120L fuel tank,
underfloor drainage pipes from the forward storage pockets and
underfloor electrical conduit. I also made a mould up for some new
fibreglass side pockets. The transom main section is also complete as
well. I am in the process of making a mould to finish of the top
section of the hull where the original outboard well once was. When
this is all done then I have to apply the flow coat to the inside to
finish the job off.

Sounds great!!! Well done!
Did you find any black filler under the stringers/keel?

Got any pics? Gunna upload them to the web somewhere?

Seasons greets to all in aus fishing...

Lindsay