![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I have a 24v motorguide great white trolling motor, that I converted
last fall to the digital series. I have an inline auto reset circuit breaker connected to the pos cable near battery. hen I run the motor on med to high the motor cuts out and comes back on in a few seconds. Any ideas? Could I have a bad connection or bad breaker that get too much heat that triggers the breaker? Thanks! |
#2
|
|||
|
|||
![]() "tim3313" wrote in message ups.com... I have a 24v motorguide great white trolling motor, that I converted last fall to the digital series. I have an inline auto reset circuit breaker connected to the pos cable near battery. hen I run the motor on med to high the motor cuts out and comes back on in a few seconds. Any ideas? Could I have a bad connection or bad breaker that get too much heat that triggers the breaker? Thanks! Bypass the breaker and see if that fixes it. |
#3
|
|||
|
|||
![]()
It's possible you're pulling too much current through the breaker - did you
get a more powerful motor? "tim3313" wrote in message ups.com... I have a 24v motorguide great white trolling motor, that I converted last fall to the digital series. I have an inline auto reset circuit breaker connected to the pos cable near battery. hen I run the motor on med to high the motor cuts out and comes back on in a few seconds. Any ideas? Could I have a bad connection or bad breaker that get too much heat that triggers the breaker? Thanks! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Trolling Motor | FishinJC | Bass Fishing | 6 | June 19th, 2006 03:21 AM |
Trolling motor help | BIG FISH 2006 | Bass Fishing | 0 | March 29th, 2006 02:01 AM |
Trolling Motor | Steve @ OutdoorFrontiers | Bass Fishing | 0 | January 29th, 2006 12:03 AM |
Motor Guide trolling motor | IBNFSHN | Bass Fishing | 0 | February 16th, 2005 03:59 PM |