![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I'm looking at getting a new rod 6.5 feet for my baitcaster and
wondering if any downfalls with a 2 piece rod? |
#2
|
|||
|
|||
![]()
For a 6.5' rod -- I suggest a one piece.
I use a two piece only because it is a 12' Surf Rod. Dave "1984" wrote in message ... | I'm looking at getting a new rod 6.5 feet for my baitcaster and | wondering if any downfalls with a 2 piece rod? |
#3
|
|||
|
|||
![]()
I prefer a one piece rod. The only two piece rods I have are ones that were
given to me. Disadvantages with two piece rods are the upper part of the rod wants to turn out of alignment. The pieces get stuck together. That don't have the same sensitivity as a one piece. Advantages with two piece rod are the are easier to transport in a car. Sarge |
#4
|
|||
|
|||
![]()
Hi,
We have numerous multi-section rods, and use them while travelling in Africa, our web page shows a 9.5kg (21lb) Tigerfish caught on a 6 piece spinning rod, that has also caught some very large sea fish as well. Our pages on Angola show our early fishing at Rio Longa with Tarpon to 100lbs, caught on 4 piece rods. The number of pieces of a rod are not the issue, the quality of the build and whether you use lines within the manufacturers range, or not. Any overloaded rod or poorly built rod will break - one piece or multi-sections. Choise quality and a rod to suit your needs, the number of rods that lose the tips when trapped in car or trunk doors is more than fish break! Hope that helps confuse the issue further. Cheers -- Sue & Jeri Drake UK Shark Tagging Programme http://www.ukshark.co.uk "1984" wrote in message ... I'm looking at getting a new rod 6.5 feet for my baitcaster and wondering if any downfalls with a 2 piece rod? |
#5
|
|||
|
|||
![]() "1984" wrote in message ... I'm looking at getting a new rod 6.5 feet for my baitcaster and wondering if any downfalls with a 2 piece rod? Pitfalls of a two piece rod? Sure there are. Most one piece rods are more sensitive and stronger as well. Plus, if you break the rod down often, you'll wear the ferrule, making for a loose fit. This in turn causes a greater sensitivity loss and the possibility of the rod flying apart at the least opportune moment. This usually happens when you have your lure irretrievably snagged and have to break off. All of my rods under 8 feet are one piece. More sensitive, more durable, what more do you need? -- Steve @ OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
***** 2 PC. RODS***** Whats your take? | Who Cares | Bass Fishing | 30 | October 31st, 2003 01:27 PM |
cortland pro crest 3 piece travel 8 foot | no | Fly Fishing | 1 | October 29th, 2003 12:53 PM |
One Rod | Russell Durtschi | Fly Fishing | 82 | October 6th, 2003 11:05 AM |