A Fishing forum. FishingBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » FishingBanter forum » uk.rec.fishing newsgroups » UK Sea Fishing
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Fishfinders - 3D or not 3D, that is the question.



 
 
Thread Tools Display Modes
  #1  
Old September 11th, 2005, 01:21 PM
Pig Sick
external usenet poster
 
Posts: n/a
Default Fishfinders - 3D or not 3D, that is the question.

I'm replacing my trusty old Lowrance X65 fishfinder and am considering
a 3D unit. It seems to make so much sense...and yet it's difficult to
hear a good word said for them on any Newsgroup. What's more, the
comments all seem very dated and may not relate to newer technology -
so what are the latest views?

My impression is that a few years ago there were more 3D units on offer
than now - that suggests either the market was a lot smaller than the
manufacturers thought or the technology couldn't meet the market need.

I'm fishing my home waters here in Scotland in the 70 - 250ft range (so
all these negative comments about 3D in shallow water aren't relevant)
in an area that is only lightly fished and about which there's little
local knowledge of underwater features, hotspots, wrecks etc (so 3D
sounds ideal).

Looking at the units available only the Hummingbird Matrix 47 3D comes
up and on paper it looks good. Their Matrix 37 with side-imaging looks
very impressive too - who could argue with the screen shots on their
website (http://www.humminbird.com/generic2.asp?ID=514)- have a look,
they're incredible. But looking at Newsgroup comments about Hummingbird
they come in for a slating.

So what's a guy to do? What's your considered view? Hummingbird bad? 3D
bad? Do I stick to 2D and keep looking at the sea bed through a
pin-hole?

  #2  
Old September 11th, 2005, 05:51 PM
external usenet poster
 
Posts: n/a
Default

it looks interesting .... I am not a fisherman but could iamgine that
just by seing the fish on the screen doesnt mean you catch them or
they are stillt here by the time you get the hook down ..

I see fishfinders more useful to find the fishs depth and habitat
rather than the fish itself ...

I heard people say these 3D / forward looking units work well,
apparently commericlas use them ... but its "too easy" to catch fish
....

Also consider that the actual image you will get wont look as it does
on the screen ... it can be quiet a challenge to get a normal finder to
read properly a 6 beam transducer may be more difficult ...

Matt

  #3  
Old September 11th, 2005, 07:12 PM
Keith M
external usenet poster
 
Posts: n/a
Default

I read the web site which says effective to 100ft
You are talking of 70 to 250ft
a.. Side beams are extremely narrow front to back providing "thin slices"
of the bottom for high resolution imaging.
b.. Side Beams look out to 240 feet, with a depth limitation of 100 feet.
Save your money unless you are into hydroghraphic surveying.

Keith M

"Pig Sick" wrote in message
ups.com...
I'm replacing my trusty old Lowrance X65 fishfinder and am considering
a 3D unit. It seems to make so much sense...and yet it's difficult to
hear a good word said for them on any Newsgroup. What's more, the
comments all seem very dated and may not relate to newer technology -
so what are the latest views?

My impression is that a few years ago there were more 3D units on offer
than now - that suggests either the market was a lot smaller than the
manufacturers thought or the technology couldn't meet the market need.

I'm fishing my home waters here in Scotland in the 70 - 250ft range (so
all these negative comments about 3D in shallow water aren't relevant)
in an area that is only lightly fished and about which there's little
local knowledge of underwater features, hotspots, wrecks etc (so 3D
sounds ideal).

Looking at the units available only the Hummingbird Matrix 47 3D comes
up and on paper it looks good. Their Matrix 37 with side-imaging looks
very impressive too - who could argue with the screen shots on their
website (http://www.humminbird.com/generic2.asp?ID=514)- have a look,
they're incredible. But looking at Newsgroup comments about Hummingbird
they come in for a slating.

So what's a guy to do? What's your considered view? Hummingbird bad? 3D
bad? Do I stick to 2D and keep looking at the sea bed through a
pin-hole?




  #4  
Old October 7th, 2005, 09:55 AM
Dom
external usenet poster
 
Posts: n/a
Default

Go with 4D. Not only will it show you where the fish are, but also when
they'll be there.


  #5  
Old October 7th, 2005, 10:15 AM
Steve Walker
external usenet poster
 
Posts: n/a
Default

In message ws.net,
Dom writes
Go with 4D. Not only will it show you where the fish are, but also when
they'll be there.


Would that be the sort you need a sonic screwdriver to fix?

--
Steve Walker
  #6  
Old October 7th, 2005, 05:43 PM
John
external usenet poster
 
Posts: n/a
Default

If you're still on the fence about 2D or 3D, this may help.

Since you're using your fishfinder for fishing a 3D unit may be of use
to you. Consider what kind of fish you are targeting. If these fish
seek bottom structure, then 3D may be of value to you.

Trade in features you don't use for a better quality unit. Look at your
current unit and figure what features you use and don't use.Dual
frequency is a handy feature. Your X65 is a single frequency unit, 192
khz I think. Bottom zoom is a seldom used feature.

If you're working with a budget consider buying a better quality 2D
unit instead of a lesser quality, but similarly price 3D unit.

If you're looking for another Lowrance, I do not believe that they make
a 3D unit. Humminbird's Matrix 47 (
http://www.humminbird.com/products.asp?ID=492 ) sells for less than
$500. Their new 900 series 947C (
http://www.humminbird.com/products.asp?ID=510 ) , which is color and
has a built in chart plotter, goes for about to $1600. We usually can
beat their prices and we ship to Europe. Let me know if you want exact
prices.

John
Retail4Wholesale.com

  #7  
Old October 7th, 2005, 10:09 PM
Dom
external usenet poster
 
Posts: n/a
Default

....and a laser wrench.


  #8  
Old October 8th, 2005, 08:47 AM
Dichromus Dichromus is offline
Junior Member
 
First recorded activity by FishingBanter: Sep 2005
Posts: 5
Talking

You may also find an Interossitor helpful...
  #9  
Old October 11th, 2005, 12:21 AM
Pig Sick
external usenet poster
 
Posts: n/a
Default

Thanks for that, John. I was just going to get a better quality 2D unit
but then I thought, wait a minute, most of the magazine articles I read
are about people using their 2D units fishing over wrecks and banks
that are well-known features to all and sundry in the heavily used
waters they fish, mostly around England. I on the other hand am fishing
in remote, seldom (if ever) fished waters around my home in Scotland
(Google Earth 58degrees 1minute N, 5degrees 26minutes W), and though my
father and grandfather fished these same waters before me, none of us
know that much about the bottom features. The old marks don't seem to
work any more and I need to go prospecting. So, I thought, what better
way than to strap on a 3D? And if I want 2D mode I just flick a switch.
But I seem to be the only one thinking this way, which worries me a
tad.

I may yet come to you for a price for the Matrix 47 - I already got a
GPS.

Iain

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Hello all....question on tow vehicle Jeff Bass Fishing 9 March 11th, 2005 09:55 PM
Sonar Question Joshuall Bass Fishing 7 February 8th, 2005 11:15 AM
Steve Huber - Lure Question GL3Loomis Bass Fishing 3 February 3rd, 2005 03:25 AM
Old, old, antique fishing reel question? Suthern Transplant Bass Fishing 1 January 9th, 2005 02:07 AM
Tournament Question Chuck Coger Bass Fishing 7 October 1st, 2003 10:48 PM


All times are GMT +1. The time now is 09:22 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 FishingBanter.
The comments are property of their posters.