![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
I appreciate everyone's comments and suggestions... just a bit of side info
about my use... I will be using this on a nice sized reservoir or two here in the Baltimore area. I've been out before with a 12volt setup and 24-30lb motor and was stranded a couple of times when the juice ran out (one time was a windy day and I was battling a good headwind, small little waves, and some current). Since then I've taken an extra battery with me and it has come in handy at least twice. I hate being stranded!! Soooooooooooo, (making a short story longer) I figured that as long as I'm going to be using 2 batteries I might as well make it a 24 volt system. And, at slower speeds, the 65lb motor should be using less current (and being more effecient) that a smaller motor at the same speed. And, with a variable speed control, I can run at any speed I choose. Is the 65lb motor overkill? Maybe. But, one other thing I hate is when a late afternoon summer storm pops up to be puttzing along against a headwind knowing that all holy hell is going to break loose if you don't get back to shore in a hurry. And, it shouldn't be any different than running a 2hp - 4hp motor on this thing... I think the boat is actually rated for 6hp. Sooooooo -- that said -- any other recommendations for batteries or chargers? -- Marty S. Baltimore, MD USA "Marty S." wrote in message ... Hi all... I'm looking for suggestions of deep cycle batteries for my 12' jon boat with a 65lb, 24volt Minn Kota transom mounted motor. I will be using it in a local reservoir that only allows electric motors. I'm looking for a good trade-off between the weight of the battery (I'm going to be needing 2 batteries), the reserve time & amps, and cost. I've ruled out the sealed gel-type batteries due to their weight and COST! The total capacity of my boat is about 500lbs (including equipment and people). Any suggestions? From here I have access to most battery distributors and outdoor-type stores including Bass Pro Shops and Cabela's. And -- suggestions for a charger. I'm supposing that I will be taking the batteries out of the boat at the end of the day and recharging them in my garage. I've heard not to let the batteries run down too far and that recharging them after use is the best way to maintain a good charge -- yes?? Is this right? Thanks in advance!!! -- Marty S. Baltimore, MD USA |
#12
|
|||
|
|||
![]()
I run a 50 pound MK 12 volt on my 14-1/6 footer and fish lots of
'lectrikonly lakes. One group 27 deep cycle battery from wallyworld will fish me two full days before I neven notice a decline if it's not too windy. RichZ© www.richz.com/fishing |
#13
|
|||
|
|||
![]()
RichZ wrote:
4-1/6 footer Oops. 14-1/2 footer One group 27 deep cycle battery Oops again. Group 29. RichZ© www.richz.com/fishing |
#14
|
|||
|
|||
![]()
Steve;
You do have some very good points, but please allow me to expand just a bit here. (My excuse is that I pounded out my answering post while I was ALMOST running late for work last night :-) "Steve @ OutdoorFrontiers" wrote in message ... One of the reasons I didn't question the setup is the fact that I don't know how he's going to be using the rig. If he were to actually use the trolling motor for trolling, a typical 12 volt system isn't going to cut it for a full day of fishing. I'd rather be overpowered than under any day of the week. I was trying to make the point (poorly) that with a boat of such light weight, you can achieve very good results with a motor smaller than 65lb. While I stated that my motor was only a 36lb unit, MK also makes the Endura model in 40lb., 46lb., 50lb., and 55lb ratings, all with 12v. Any of these would give even better performance, in terms of speed, than the 36lb unit. And with a boat of the size and weight, of his Jon boat, any of these should be capable of going all day on one battery. I just didn't say this very well at all. One other thing that I thought of while at work last night, is that any system he uses that requires 2 batteries is going to seriously impact his available weight capacity. One trolling motor plus two batteries is going to weigh in at, or over 100 lbs. This would only leave him with approx. 400 lbs. of capacity, this would allow only 2 people (in my weight range :-) with no gear. Better would be the trolling motor and one battery, if at all possible. Now, if he's strictly going to be positioning the boat, then I agree, 24 might be overkill and a 12 volt might be enough. As far as the motor selection, maybe it's what he already has and he doesn't want to buy a different trolling motor. Yeah, I also thought of this while at work. If it is true that he already has this motor, then the only advice I could give would be to fish alone, instead taking the chance of pushing the weight on the boat to, or over, it's weight rating. It is always better to be under the weight rating on any boat, rather than at, or over the rating, for safety and insurance requirements. In case of any accident, I never want to hear what my insurance company would say when they found out the boat was overloaded. As to a charger selection, I picked up an automatic battery charger at Wal-Mart for $39.95 and used it for quite a while, until I got a boat with an on-board charger system. I always had full batteries overnight and had good battery life. -- I fully agree that having a dedicated charger is the best way to go. For me, I already had the portable charger years before I ever owned a boat, with the attendent batteries to be charged. Just have not seen the neccessity of buying a seperate charger at this time. (Of course, with the wifey questioning every little purchase, this helps keep me (more) honest, and with fewer toys that she says I don't need :-) Bob Steve @ OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com "Bob" wrote in message news:Razlc.25112$I%1.1681173@attbi_s51... Why is nobody picking up on this setup? Let's review your rig; |
#15
|
|||
|
|||
![]() "Jim" wrote in message ... However, based on that limited experience noted above, in addition to the required life jackets for the passenger or two, there WILL also be a life jacket attached to the battery itself, just in case. :^) If you are expecting the life jacket to save the battery in case of an upset then you better strap a couple of them on! I would assume that you would be trying to save an optima battery, as any lead acid would become worthless once it was dunked or turned over. An Optima D34 weighs about 44 pounds. It is pretty dense, measuring in at 10 x 6.8 x 7.8 (ignoring all the contours that would reduce its flotation) it will displace 530 cu inches of water when it gets dunked. The 530 cu-in would displace 530 cu-in/231 cu-in per gallon = 2.29 gallons of water, which would weigh 2.29* 8.3 lbs per gallon = 19 pounds. 44 pounds dry - 19 pounds displacement and you still have 25 pounds you need to float. The regulation for a type II or III life jacket is that they have a minimum of 15.5 pounds of floatation. It will take at least two life jackets to support the battery. Of course, the battery should be strapped down to the boat so its the boat you need to keep from sinking. Rod |
#16
|
|||
|
|||
![]()
Rod,
Good point. Even though the battery would most likely be trashed, I plan on using this particular boat in shallow salt water marshes and would not want to leave the battery if it were lost overboard. At the very least, the life jacket would be a marker to retrieve the battery at low tide. -Jim Rod McInnis wrote: If you are expecting the life jacket to save the battery in case of an upset then you better strap a couple of them on! removed |
#17
|
|||
|
|||
![]()
Joseph Stachyra wrote:
Dear Marty: You say weight is a problem, and you say your use is only your local reservoir. and your boat is very small, thus meaning, your not going into deep or far away waters. 1. response Car Batteries are lighter than deep cycle and cheaper, why not. Your not going to sea. 2. Or go to Sears and get two deep cycle batteries they have many sizes. 3. open that wallet, let the moths out of it, and buy a bigger boat and do it right. "Marty S." wrote in message ... Hi all... I'm looking for suggestions of deep cycle batteries for my 12' jon boat with a 65lb, 24volt Minn Kota transom mounted motor. I will be using it in a local reservoir that only allows electric motors. I'm looking for a good trade-off between the weight of the battery (I'm going to be needing 2 batteries), the reserve time & amps, and cost. I've ruled out the sealed gel-type batteries due to their weight and COST! The total capacity of my boat is about 500lbs (including equipment and people). Any suggestions? From here I have access to most battery distributors and outdoor-type stores including Bass Pro Shops and Cabela's. And -- suggestions for a charger. I'm supposing that I will be taking the batteries out of the boat at the end of the day and recharging them in my garage. I've heard not to let the batteries run down too far and that recharging them after use is the best way to maintain a good charge -- Marty S. Baltimore, MD USA Aww, rig a wire from your auto battery, and plug your boat into it. You might have an extra circuit in your towing harness you could use. Your car should be able to charge the batteries, if you hook them up in parallel for charging, and /or you can continue / start the charge in the boat in the driveway after you get home, if the trip back doesn't do it. Rig a charge harness for the boat, so you don't try to charge 24 v battery from 12 v vehicle or charger, or you could engineer a switch arrangement, but I would not reccommend that, as it only takes once if you hook your 24 v setup to the 12 v vehicle by forgetting the switch before connecting the wire. You could do serious damage to your entire vehicle electrical system if you got it wrong. Your alternator may not be able to handle the extra charge current, but you can check that with your auto dealer. If you have a heavy duty alternator, it should be OK. Why lug them around? Check the state of charge with a hydrometer, and top up with steam distilled water if needed. Terry K |
#18
|
|||
|
|||
![]() "Terry Spragg" wrote in message .rogers.com... Aww, rig a wire from your auto battery, and plug your boat into it. I doubt that you would ever get more than 10 amps of charge from this setup. At that rate, it would take about 10 hours of driving around to get the battery from "dead" to around 80%, and then another 6 hours to get it to 95%, and it might not ever get it to 100% If he lives within an hour of the lake, the amount of charge that he would get from this wouldn't hardly be worth the effort to rig it up. Rod |
|
Thread Tools | |
Display Modes | |
|
|