![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I woke up this afternoon (still on night shift) hungry to fish for
trout. I have only been bass fishing for the last month. Smallmouth fishing is a fine pastime but at heart I'm a trouter. Checking the local weather summary I saw that the low the night before never got below 74. A look at the River's USGS site confirmed that the water temp never dropped below 68. So the River was out. Instead there was my ace in the hole, a spring fed stream about 20 miles away. Usually cold enough even in the hottest weather to fish, I threw in my vest and light rods and headed west. (I also tossed in the bass rods and my warmwater man purse because... you never know.) I got to the creek. It was a little stained from the last few days' rain, which was unusual for this water. I dipped my thermometer in and it read 72. ****e! I drove a mile upstream, took the temp and got the same dismal result. There were caddis fluttering above the water and even a small riser but, in the end, my virtue (such as it is) remained intact and I left the brookies to make their way through the upcoming week's forecast hot spell. So I drove north, past a local C&W festival where the trailers were packed just far enough apart to open their side doors. What a ghastly, crowded affair. Eventually I came to a bridge where the River slides under the highway. Stopped and took its temp. 71. No go. A dozen or so miles later I pulled into an access point on the Big River near Rhinelander. The water was low and falling. I suppose the dam upstream was saving its water to run air conditioners tomorrow but it made for easy wading on a stretch of water that can be pushy when at higher levels. I fished upstream, a deer splashing across the shallows ahead of me. No fish for almost a quarter mile of river, changing flies after every 15 minutes or so. Finally I got a hit on the tried and true red/tan Diver. Another cast to the same spot brought another swirl and this time my strike brought back only a bitten off tippet, my fly assumptively left in the pike or muskie's jaws. It was getting late, with the sun a handspan or so above the horizon. I fished back downstream, casting another Diver. A cast along a pine shaded shoreline followed by a twitch and then a long pause brought a small strike. I tightened and all hell broke loose. The fish roared towards deeper water (he was lying in less than a foot when he struck). The rod was in a deep C. The fish rolled and then streaked off again, spinning the spool so fast that, for the first time in my life, I was left with the proverbial skinned and soar knuckles. I barely had the fish under control. Any line I gained was lost... with interest. After about 5 minutes though he seemed to be growing weaker and I brought him to within two rod lengths. Then he jumped. Six pounds of smallmouth (my guess, prove me wrong) hung suspended in mid air with my fly in his jaws. Then he splashed back into the river while the fly flew back towards my head. Oh my. Nothing to do but keep fishing, right? Got another big swirl a hundred feet down stream but missed. I fished down to a wide shallow riffle, casting across the current towards where a huge fish had rolled near the other bank but the fish, probably a muskie, wasn't interested in my dinky offering. Then I noticed that the few Ephorons (white mayflies) that had been cruising the river earlier had grown into a horde. The hatch rose rapidly in intensity and I scoured the water for any risers. I keep a few #14 White Wulffs in my bass box for just such an emergency. But other than minnows and baby smallies nothing seemed interested in the blizzard of bugs who were shedding, flirting and dying by the millions in the big pool by the boat landing. Having about a half an hour of daylight left I fished downstream to a small set of rapids, taking pictures of the mayflies that covered my hat, neck and shirt. I reached a big granite boulder, covered with moss. The mayflies were molting on its rough surface. I cast my Diver out below me and then turned to take a couple shots of the White Flies on the rock with the Canon. When I looked up there were a series of rings spreading out from where my fly had been and the line was arrowing out into the current. Thank the Red Gods for soft deerhair divers! It must have felt foodlike enough for the bass to hang on. I tightened and again faced a tougher opponent than I anticipated. While not as big as the lost fish it still pulled out line at will for 3 or 4 minutes and jumped clear of the water a couple times. Finally I lead him into shallow water with the Dahlberg barely stuck in the skin on the outside of his jaw. A couple of flash pics and he went back. It was almost dark so I waded back to the access and unstrung the rod and drove home. I've got to tie some more Divers. http://img.photobucket.com/albums/v2.../IMG_1970a.jpg http://img.photobucket.com/albums/v2.../IMG_1978a.jpg http://img.photobucket.com/albums/v2.../IMG_1981a.jpg http://img.photobucket.com/albums/v2.../IMG_1983a.jpg http://img.photobucket.com/albums/v2.../IMG_1986a.jpg http://img.photobucket.com/albums/v2.../IMG_1994a.jpg http://img.photobucket.com/albums/v2.../IMG_1996a.jpg http://img.photobucket.com/albums/v2.../IMG_2006a.jpg http://img.photobucket.com/albums/v2.../IMG_2007a.jpg http://img.photobucket.com/albums/v2.../IMG_2009a.jpg http://img.photobucket.com/albums/v2.../IMG_2011a.jpg HTH George C. |
#2
|
|||
|
|||
![]() "George Cleveland" wrote in message news ![]() I woke up this afternoon (still on night shift) hungry to fish for trout. I have only been bass fishing for the last month. Smallmouth fishing is a fine pastime but at heart I'm a trouter. seems to me you'll do quite well as a "smallmouther", george. thanks for the great tr. yfitons wayno |
#3
|
|||
|
|||
![]()
On Mon, 10 Aug 2009 11:31:25 -0400, "Wayne Harrison"
wrote: "George Cleveland" wrote in message news ![]() I woke up this afternoon (still on night shift) hungry to fish for trout. I have only been bass fishing for the last month. Smallmouth fishing is a fine pastime but at heart I'm a trouter. seems to me you'll do quite well as a "smallmouther", george. thanks for the great tr. yfitons wayno Thanks, Wayne. We try. Although my after-the-fact proofreader(Wife Jacci) immediately picked up on my typo "soar knuckles". D'oh!! Geo. |
#4
|
|||
|
|||
![]()
great pics great report as usual George........what size leader and
tippet were you using......... |
#5
|
|||
|
|||
![]()
On Mon, 10 Aug 2009 19:46:35 -0700 (PDT), Mike
wrote: great pics great report as usual George........what size leader and tippet were you using......... With deerhair divers and bugs I use a factory 7 1/2' 0X or 1X leader with 6# Maxima for tippet. I think the stiffness helps turn the bugs over. When I go to streamers and buggers I tie on a Orvis Super Strong 3X tippet, about 2' long. It actually tests stronger than the Maxima but is a smaller diameter. I have flourocarbon but I don't use it very often... more laziness in having to tie a triple surgeons knot than anything else... even though it would probably be better on the sunken flies. I have knottable steel tippet but I'm absolutely convinced it reduces both bass and walleye strikes. And so I only tie it on if I'm getting a lot of bite offs. George C. |
#6
|
|||
|
|||
![]()
George Cleveland wrote:
On Mon, 10 Aug 2009 11:31:25 -0400, "Wayne Harrison" wrote: "George Cleveland" wrote in message news ![]() I woke up this afternoon (still on night shift) hungry to fish for trout. I have only been bass fishing for the last month. Smallmouth fishing is a fine pastime but at heart I'm a trouter. seems to me you'll do quite well as a "smallmouther", george. thanks for the great tr. yfitons wayno Thanks, Wayne. We try. Although my after-the-fact proofreader(Wife Jacci) immediately picked up on my typo "soar knuckles". D'oh!! Geo. actually...an excellent descriptive...in an altogether finely pictured story. jeff (a soar-y reader) |
#7
|
|||
|
|||
![]()
On Aug 11, 6:58*am, George Cleveland
wrote: On Mon, 10 Aug 2009 19:46:35 -0700 (PDT), Mike wrote: great pics great report as usual George........what size leader and tippet were you using......... With deerhair divers and bugs I use a factory 7 1/2' 0X or 1X *leader with 6# Maxima for tippet. *I think the stiffness helps turn the bugs over. When I go to streamers and *buggers I tie on a Orvis Super Strong 3X tippet, about 2' long. It actually tests stronger than the Maxima but is a smaller diameter. I have flourocarbon but I don't use it very often... more laziness in having to tie a triple surgeons knot than anything else... even though it would probably be better on the sunken flies. I have knottable steel tippet but I'm absolutely convinced it reduces both bass and walleye strikes. And so I only tie it on if I'm getting a lot of bite offs. George C. Do you have a ref. for knottable steel tippets? I have had to use custom stainless twisted leaders, tied on BEFORE tying the fly, when casting to 'cudas. cheers oz |
#8
|
|||
|
|||
![]()
On Tue, 11 Aug 2009 21:00:01 -0700 (PDT), MajorOz
wrote: On Aug 11, 6:58*am, George Cleveland wrote: On Mon, 10 Aug 2009 19:46:35 -0700 (PDT), Mike wrote: great pics great report as usual George........what size leader and tippet were you using......... With deerhair divers and bugs I use a factory 7 1/2' 0X or 1X *leader with 6# Maxima for tippet. *I think the stiffness helps turn the bugs over. When I go to streamers and *buggers I tie on a Orvis Super Strong 3X tippet, about 2' long. It actually tests stronger than the Maxima but is a smaller diameter. I have flourocarbon but I don't use it very often... more laziness in having to tie a triple surgeons knot than anything else... even though it would probably be better on the sunken flies. I have knottable steel tippet but I'm absolutely convinced it reduces both bass and walleye strikes. And so I only tie it on if I'm getting a lot of bite offs. George C. Do you have a ref. for knottable steel tippets? I have had to use custom stainless twisted leaders, tied on BEFORE tying the fly, when casting to 'cudas. cheers oz Sure. There are a few out there. http://www.tygerleader.com/ http://www.ezflyfish.com/cltocrwi.html http://www.americanfishingwire.com/smsupreme.asp I've used all three and I like the Climax/Cortland Toothy Critter the best (seems to kink less) but they all work. Geo. |
#9
|
|||
|
|||
![]()
George Cleveland wrote:
MajorOz wrote: George Cleveland wrote: I have knottable steel tippet but I'm absolutely convinced it reduces both bass and walleye strikes. And so I only tie it on if I'm getting a lot of bite offs. Do you have a ref. for knottable steel tippets? I have had to use custom stainless twisted leaders, tied on BEFORE tying the fly, when casting to 'cudas. Sure. There are a few out there. http://www.tygerleader.com/ http://www.ezflyfish.com/cltocrwi.html http://www.americanfishingwire.com/smsupreme.asp I've used all three and I like the Climax/Cortland Toothy Critter the best (seems to kink less) but they all work. The best wire leader I've found is Boa No-Kink. http://www.malinco.com/fishing/boa.html It's titanium and more expensive than steel but it's way better than steel in terms of kinking and visibility in the water. I use the 30 lb. on all my muskie leaders. -- Ken Fortenberry |
#10
|
|||
|
|||
![]()
On Wed, 12 Aug 2009 09:21:08 -0500, Ken Fortenberry
wrote: George Cleveland wrote: MajorOz wrote: George Cleveland wrote: I have knottable steel tippet but I'm absolutely convinced it reduces both bass and walleye strikes. And so I only tie it on if I'm getting a lot of bite offs. Do you have a ref. for knottable steel tippets? I have had to use custom stainless twisted leaders, tied on BEFORE tying the fly, when casting to 'cudas. Sure. There are a few out there. http://www.tygerleader.com/ http://www.ezflyfish.com/cltocrwi.html http://www.americanfishingwire.com/smsupreme.asp I've used all three and I like the Climax/Cortland Toothy Critter the best (seems to kink less) but they all work. The best wire leader I've found is Boa No-Kink. http://www.malinco.com/fishing/boa.html It's titanium and more expensive than steel but it's way better than steel in terms of kinking and visibility in the water. I use the 30 lb. on all my muskie leaders. Actually thats cheaper than Tyger wire, which goes for close to $10/10'. I'll give it a try. Thanks! Geo. |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
TR- Bugs | George Cleveland | Fly Fishing | 1 | June 2nd, 2009 01:34 AM |
Glo Bugs | Corndog[_18_] | Fly Fishing Tying | 42 | January 3rd, 2008 11:54 AM |
Glo Bugs | theartoflee[_12_] | Fly Fishing Tying | 3 | December 20th, 2007 12:18 AM |
Bugs!! | George Cleveland | Fly Fishing | 26 | June 11th, 2005 12:39 AM |
Bass Bugs? | Richard Liebert | Bass Fishing | 7 | February 7th, 2005 10:58 PM |