|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 27th, 2004, 10:22 PM
|
|||
|
|||
Platform on a Lund
I am searching for information anyone might have on putting a polling
platform on a Lund 18' Alaskan. I had a helpful post from someone about a transom mount but I am concerned about the stress on the boats structure. Has anyone out there had experience with this boat? 
|
|
#2
January 28th, 2004, 05:12 AM
|
|||
|
|||
|
Platform on a Lund
Take the boat to a welding shop and have them add some extra support on the
gunwales and transom You can have them weld pipe to the inside of the gunwale and on the inside of the corner of the transom and gunwale. Make an insert to slide into that pipe and frame up the polling platform. You then remove the platform by simple bolting. I had a similar design made for a 16 foot flat (Jon) boat. Sarge
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lund boat accessories | JackTr | Bass Fishing | 1 | February 16th, 2004 09:56 PM |
| Lund boat in slip | JackTr | Bass Fishing | 0 | February 9th, 2004 04:52 PM |
| SW spinnerbaits | RR | Bass Fishing | 81 | January 28th, 2004 02:41 AM |
| Platform On Lund Alaskan | John Kaufmann | Fly Fishing | 0 | January 27th, 2004 10:22 PM |
Linear Mode
