|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 26th, 2005, 02:59 PM
|
|||
|
|||
Eye Repair
One of the eyes of my casting rod has lost the inner coating (the plastic stuff that protects the line). It is the third eye down from the tip. I have replaced the tip eye before, but this is the first time that I have encountered this problem. The eye is basically ok other than that. I wonder if I replace the coating some how? The rod is a BPS Extreme, which uses Fiji eyes. If try to replace this eye, I will have to remove that plastic wrap that hold the eye. Would that be difficult to do without damaging the rod? Or I could just cut the eye off. Suggestions?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wader Repair | Tony & Barb Vellturo | Fly Fishing | 3 | June 9th, 2004 01:06 AM |
| FS 17' Yar-Craft fiberglass bow rider, 120hp Mercrusier I/O, cracked block. Needs repair | Dan S | General Discussion | 0 | May 7th, 2004 03:40 PM |
| Neoprene wader repair. | Kim Sawyer | UK Game Fishing | 17 | March 31st, 2004 08:39 PM |
| need cane rod repair in LA | Dan | Fly Fishing | 0 | November 24th, 2003 11:56 PM |
| Wader repair | Snoop | Fly Fishing | 7 | October 1st, 2003 04:54 AM |
Threaded Mode