|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
July 8th, 2005, 09:26 PM
|
|||
|
|||
"Todd Copeland" wrote in message nk.net... wrote in message oups.com... Hi; I have a 1990 Bass Tracker Deep Pro v17. Can anyone tell me how to get at the bilge pump? It needs to be replaced and I can't see any way to get at it? I have a 1994 Tracker TX and the bilge pump is located on the inside of the transom, on the floor and near the drain plug. It is probably an Atwood (red, white, and blue). In that case, it should twist off of it's base. You mean someone *other* than Atwood makes a bilge pump? lol It was a joke people...just a joke... Take a look at this photo: http://www.bassingfools.com/tracker/.../bilgepump.jpg 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Questions on a used Bass Tracker | Todd Copeland | Bass Fishing | 26 | March 30th, 2005 06:24 PM |
| Is this news? Or am I just slow finding this out? | Charles B. Summers | Bass Fishing | 14 | July 23rd, 2004 10:39 PM |
| Pre-season bass fishing - ethical ? Destructive ? | Shawn | Bass Fishing | 1 | May 19th, 2004 02:27 AM |
| A Bass is a Bass | Rick | Bass Fishing | 3 | March 17th, 2004 01:44 AM |
| Okeechobee Journal (long) | TNBass | Bass Fishing | 14 | October 20th, 2003 05:10 AM |
Threaded Mode