|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
May 18th, 2004, 04:19 AM
|
|||
|
|||
horrible experience with mercury outboard - advice needed!
Mercury has district reps that you can get a hold of thru the factory, it's
their job to take care of the customer. The dealer should have called them from the get go if a motor trashed on the first outing, as a quality control check if nothing else, so they could get the engine back to the factory to see what was up. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice needed for bass busting on shad | SHRED | Bass Fishing | 8 | October 12th, 2003 12:17 PM |
| Advice needed for problem with Itasca neoprene waders | David H. Lipman | General Discussion | 4 | October 6th, 2003 07:12 PM |
Threaded Mode