|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#17
May 30th, 2004, 03:29 PM
|
|||
|
|||
Spinning setup
See a.b.p.f. for two rear drag models. I fished with the Symetre model for
a couple years and loved it. But it does have one plastic gear that cannot take the pressure of catching a day of hawgs. Caught about 10 smallies in about a two hour span that weighed 5+ pounds and that plastic gear melted down, striped out, skipped a half gear, doesn't matter, I had another nice fish on and I had to hand line it in, because my reel took a crap. -- Craig Baugher Be Confident, Focused, but most of all Have FUN! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loading new line onto spinning reel | Ian \(remove the antispam\) | General Discussion | 1 | June 22nd, 2004 12:52 AM |
| Spinning rods hookset | Ken Blevins | Bass Fishing | 8 | May 24th, 2004 05:21 AM |
| Can you help a newbie out with picking out his first spinning Reel/Rod combo? | DiggityDanks | General Discussion | 15 | April 2nd, 2004 05:55 AM |
| Can you help a newbie out with picking out his first spinning Reel/Rod combo? | DiggityDanks | Bass Fishing | 17 | April 2nd, 2004 05:55 AM |
| Smallmouth Jig/Tube Spinning Rod/Reel | Rich Pierro | Bass Fishing | 0 | September 24th, 2003 02:47 PM |
Threaded Mode