|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
June 7th, 2004, 03:29 AM
|
|||
|
|||
Force 50 Problems
Fortunately it only took a couple minutes. The piston has very minor
spatter marks. Looks like it has been getting a little bit of water for quite some time. It was very clean, but fortunately no rust. The gasket just picked now to completely give up. The gasket is definitely blown the metal rim was gone for over and inch, and a small piece of the fiber was missing directly into one of the water ports. Even better news. The cylinders have no discernable ridge. I didn't mic it as I don't have an inside micrometer, but doing the finger nail test I could not feel anything at all. I think this motor has very very few hours on it. Cool deal. -- Public Fishing & Boating Forums Fishing & Boating Link Index www.YumaBassMan.com "Steve @ OutdoorFrontiers" wrote in message ... "Bob La Londe" wrote in message ... You are telling me I should pull the head before I order any parts then? LOL. It might not hurt. -- Steve @ OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Outdoorsmen for Bush | Deggie | General Discussion | 6 | April 6th, 2004 01:13 PM |
| any overweight people have problems with waders? | Steve Sullivan | General Discussion | 5 | March 29th, 2004 07:33 AM |
| For those suffering a bad winter, we have problems also. | Calif Bill | Bass Fishing | 7 | March 12th, 2004 01:14 PM |
| Problems with Group? | Josh | Bass Fishing | 7 | December 15th, 2003 03:23 PM |
Threaded Mode