|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 30th, 2006, 10:43 PM
posted to uk.rec.fishing.sea
|
|||
|
|||
Rod Problem Advice needed
I have a cpl of expensive rods that i brought from ebay. They are both brand
new 2 piece 13ft beachcasters. I cant seem to get the rods to sit right when i connect them, i end up with a clear 1 inch gap and am unable to push the rod down any further for fear of it getting stuck. They are clearly supposed to connect fully, i have a cheaper rod which sits perfectly. Are they faulty? TIA 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice needed | Jack Schmitt | Fly Fishing | 2 | July 30th, 2006 02:45 PM |
| Rod advice needed. | neil@***REMOVEME***thecoldricks.co.uk | UK Sea Fishing | 5 | June 29th, 2004 01:16 PM |
| Advice needed please | Viktor | Saltwater Fishing | 0 | June 22nd, 2004 05:33 PM |
| Advice needed for problem with Itasca neoprene waders | David H. Lipman | General Discussion | 4 | October 6th, 2003 07:12 PM |
| Advice needed for problem with Itasca neoprene waders | David H. Lipman | General Discussion | 3 | October 6th, 2003 06:40 PM |
Threaded Mode