|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
December 27th, 2006, 02:19 PM
posted to rec.outdoors.fishing.bass
|
|||
|
|||
Trolling motor power
"bleve" wrote in message ... Hello all, I have a Skeeter ZX225 which is a 20ft boat. I purchased this boat used and it had an older 67lb Motorguide on it. This motor will not move the boat in windy conditions. I want to stay with Motorguide so I don't have to drill new holes for the mount. From talking to a salesperson, they tell me the 82lb pro series should be good enough to move my boat around. The question is, will I be happy with this, Or should I go 36 volts to the 109lb version? -Bennett The 82 pound motor should work, but I've been running the 109 lb./36 volt version and it's a beast! If that motor won't hold, you have no business being on the water. -- Steve @ OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trolling Motor | FishinJC | Bass Fishing | 6 | June 19th, 2006 03:21 AM |
| Trolling Motor | Steve @ OutdoorFrontiers | Bass Fishing | 0 | January 29th, 2006 12:03 AM |
| Motor Guide trolling motor | IBNFSHN | Bass Fishing | 0 | February 16th, 2005 03:59 PM |
| Trolling motor power | Bob La Londe | Bass Fishing | 3 | October 14th, 2003 04:46 AM |
Threaded Mode