![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#8
|
|||
|
|||
![]()
I once had 15hp Johnson with the long shaft extender, and I changed it over
and it didn't amount to much work, although it was a long time ago and I don't remember the details. $50 seems pretty reasonable for the kit. I sold my leftover kit a couple of years ago for over a hundred. Bill "Doug" wrote in message news:4KzUh.6432$uF1.2205@trndny04... Hey group!! Thinking about getting a small engine for my horsepower restricted lakes, 9.9 to be exact. (Might get a 15 and put 9.9 stickers on it) I think I found one locally, I think, but it's a short shaft, and I need a long. How hard is it to put a 5 inch extension kit on this thing? Anyone got any experience with this? TIA, Doug |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Small outboard engine | Andrew | General Discussion | 4 | April 13th, 2005 08:30 PM |
Small outboard engine | Andrew | Bass Fishing | 2 | April 13th, 2005 12:12 AM |
6000+ Reel, Engine and Motor SchematicsOver 6000+ Reel, Motor and Engine Schematics | HookandSinker | Saltwater Fishing | 0 | September 17th, 2004 07:12 AM |
6000+ Reel, Engine and Motor SchematicsOver 6000+ Reel, Motor and Engine Schematics | HookandSinker | Fly Fishing Tying | 0 | September 17th, 2004 07:11 AM |
back after 30 years (maybe more) need small advice... | Mike Corrieri | Bass Fishing | 18 | July 18th, 2004 02:54 PM |