![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
![]()
On Wed, 22 Oct 2003 09:13:48 -0700, "Blain Olbert"
wrote: On a philosophical note, why care what others think about your casting style? I never met a mortal man or woman that was supremely competent to pass judgment on somebody else's casting. In my case it's because I can't lay the blasted fly down properly as much of the time as I'd like. The whole line tends to flail the water instead of settling gently and then the tippet dropping the little thing in place like a naturally falling bug. Distance where I fish is of little importance. 30 feet is fine with me (and wider than some parts of some of the streams I fish.). Putting the fly down right takes a minimum of good casting. Most good casting seems to look a lot the same, when I watch those who catch fish. So I want to be able to do that. Then do that where I'm sure the fish are. Once I can do that, I'll not worry all that much about how it looks, though I'll still want it to _feel_ right. -- rbc:vixen,Minnow Goddess,Willow Watcher,and all that sort of thing. Often taunted by trout. Only a fool would refuse to believe in luck. Only a damn fool would rely on it. http://www.visi.com/~cyli |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
casting into wind | Lure builder | Bass Fishing | 8 | May 24th, 2004 09:37 PM |
Looking for long casting tips | John Morphet | General Discussion | 4 | May 23rd, 2004 03:34 PM |
horrible experience with mercury outboard - advice needed! | J.P. | Bass Fishing | 5 | May 18th, 2004 08:32 PM |
ot casting reels | Gone Angling | Bass Fishing | 22 | January 3rd, 2004 06:45 AM |
Light or M/Light casting rod? | Dale Coleman | Bass Fishing | 6 | December 8th, 2003 01:46 PM |