|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
November 12th, 2003, 11:36 AM
|
|||
|
|||
Straightening bent rims
Frank wrote:snipunless I have a machine shop available
(which I only had when I worked on high explosives), that it will probably not come out "true." This concerns me, but you must have lived thru it for the most part. Well, it wasn't me living through it that concerned my coworkers. -- Frank Reid Reverse email to reply 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode