|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
November 25th, 2003, 03:21 PM
|
|||
|
|||
Leader & Tippet Question
Great answer Tom. I was geting ready to reply in detail until I read your
response and covered it better in fewer words than I could.. One other thing I found is that materials vary in abrasion resistance. Don't remember brand variations except that Ande mono that I use for sal****er leaders is very abrasion resistant. Lou T 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another deep cycle battery question...>>> | Marty S. | General Discussion | 7 | May 31st, 2004 11:58 AM |
| Fluorocarbon Leader / Tippet Material | schreecher | Fly Fishing | 5 | November 11th, 2003 06:49 AM |
| Hook Set on Top Waters - and a Question at the end. | Bob La Londe | Bass Fishing | 4 | October 22nd, 2003 12:49 AM |
| Tournament Question | Chuck Coger | Bass Fishing | 7 | October 1st, 2003 10:48 PM |
Threaded Mode