![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I am installing a battery switch in my boat, if I want to use one of the
trolling motor batteries to start the engine. It is a center console that is also used in the salt water besides bass fishing. The ground of the trolling battery has to be strapped with the starting battery ground, which grounds on the engine. Will this cause any ground loops or problems with corrosion etc.? I did not think so but I would like advice. Thanks in advance. Joe |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fly-In question | Roger Lester[_2_] | General Discussion | 1 | November 20th, 2008 05:54 PM |
Question | OhioFishking | Bass Fishing | 11 | March 30th, 2007 03:03 AM |
Question | SoBe | General Discussion | 0 | November 16th, 2004 02:01 AM |
rod tip question | Joe McIntosh | Fly Fishing | 19 | February 17th, 2004 03:05 AM |
cod question | seb | UK Sea Fishing | 6 | October 17th, 2003 08:55 PM |