![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
![]()
"Steve @ OutdoorFrontiers.com" wrote in message
... "Steve W." wrote in message ... OK new question... Been sitting here going through the gear. Cleaning and lubing the reels, checking poles for problems. Now for the fun part. Re-spool time. Line wise I will probably be reloading a few with braid. Those will be 15-50 pound gear. The spinning reels will probably get good mono line 4-20# range) So what have you used and how did you like it. And NO I don't want to hear how I should ONLY use line made by XXXXX because it rocks.. I'd like to hear the real stories, warts and all. Now maybe if you managed to snag a bikini off some 20 year old blond using a particular line and hook.... What are you using for leader material? Do you use a leader all the time? When you do how long are they? One guy I talked to recently was saying that he uses a leader that is able to wrap at least 4 times around the spool when the line is in. -- Steve W. Hey Steve, I'm a little different than Bob. I use braided line on ALL my reels with the exception of the rod/reel that I crappie fish with. I tried that based on some of Steve's past advice and I can see the benefit. It give really nice feedback for lots of applications. It's a really nice feel for blades, and for that being able to feel the blades turn can be critical. Often a large chaser will engulf the bait and keep swimming. If you can't feel the blades stop turning it may spit the bait before you know to speed up and sweep the rod. My problem is that except for the heaviest braids I just didn't seem to get very good life out of my braid. I broke off freshly tied 30lb on hooksets. I launched spinnerbaits into orbit on the tiniest little bind during a cast etc. I also used PowerPro for a long time, and its great initially, but it would start to get rotten on me. Perhaps it the dry air or the harsh natural radiation in Arizona, but it was really only good for a few trips on deck or maybe half a season if stored below deck. I store my boat indoors. I get the same life out of mono and good quality mono is still cheaper. In the 65# line I use for flipping and frogging I've found I can use Stren Super Braid all season until it starts to get short from cutting off and retying. I have had a few that seemed to get "rotten," but those were spooled up on rods I use every single time I go out. Rods that were on deck and exposed to the Arizona sun 50-60 days a year or more. I don't disagree with Steve, and I definitely see the appeal of using all braid for all except a few of the most severe clear water finesse presentations. I even know guys who fish cranks and popper on braid, but you better have the right rod for the job if you do. Its really easy to straighten out those light hooks and rip them out of the fish. (The pros I know who do this also usually swap out all the hooks on those baits too.) Ultimately you have to take all this information and figure out what works best FOR YOU. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Old fly lines | Bob[_3_] | Fly Fishing | 1 | October 3rd, 2009 02:28 PM |
Lines | MC | Fly Fishing | 2 | November 11th, 2007 10:57 AM |
hi-vis lines | Andrew Horvath | Bass Fishing | 0 | October 4th, 2007 07:16 PM |
fly lines | mat | Fly Fishing | 1 | September 22nd, 2006 05:27 PM |
fly lines | gary | Fly Fishing | 5 | January 8th, 2004 08:01 PM |