Knot question....

On Jun 14, 5:26*am, "Don Phillipson" wrote:

Consider attaching a permanent leader butt of mono of 2/3 the
diameter of the line tip.. * I still use Maxima for this purpose,
about 0.025 inch diam. which is fairly stiff (desirable) but
flexible enough to make a secure nail not. *(Finer mono, e.g.
15 lb. BS or 0.015" diam. is likelier to cut into the line
coating.)

Good advice; however, a supple butt section is better than a stiff
one. The reason is pretty simple: any stiffness in the leader will rob
the cast of energy when the the loop of the cast reaches it. The loop
"tries" to bend the stiff section, and the energy that the bending
consumes is lost.