|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
December 22nd, 2003, 10:54 AM
|
|||
|
|||
Reels
Mike Connor wrote:
"rw" schrieb im Newsbeitrag link.net... http://www.supraalloys.com/Machining_titanium.htm -- Cut "to the chase" for my email address. First class! Thanks! Unfortunately, the alloy I have is an airframe grade alloy, and I do not know its specific properties, but this site will be of great help nevertheless. Perhaps I can find out the properties of the stuff somewhere. If its airframe grade, its probably a 6Al/4V (aluminum/vanadium) mix, which I would think would be better than the "normal" 3/2.5 mix. BTW, I don't really know what I'm talking about... my knowledge of titanium comes from the bicycle industry. - Dave 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front Drag Reels | Jack Schmitt | Bass Fishing | 0 | June 13th, 2004 06:37 PM |
| adg fly rods and reels?? | steve sullivan | General Discussion | 24 | March 26th, 2004 06:27 AM |
| adg fly rods and reels?? | steve sullivan | Fly Fishing | 26 | March 26th, 2004 06:27 AM |
| ot casting reels | Gone Angling | Bass Fishing | 22 | January 3rd, 2004 06:45 AM |
| Who Are The Guru's of Reels | Craig | Bass Fishing | 6 | January 1st, 2004 10:10 AM |
Threaded Mode