|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 11th, 2004, 05:06 PM
|
|||
|
|||
Soft Side of the Blank
Trying to find out where the put the guides
on this fly rod. Which is the soft side? The top as I push down or side that faces down toward the table. The inside of the curve or the outside? Where do the guides go? Any guide spacing numbers for an IM6 8'6" 4 wt? thanks to all Skip 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hook Size For Soft Plastics | alwaysfishking | Bass Fishing | 1 | June 2nd, 2004 03:16 PM |
| Finnesse Soft Craws | Bob La Londe | Bass Fishing | 10 | May 3rd, 2004 05:08 PM |
| denser, heavier soft plastic (worm) resin | Salmo Bytes | General Discussion | 0 | January 22nd, 2004 08:56 PM |
| Rod Action vs. Power(freakin long daft) | Dave Norton | Bass Fishing | 11 | October 28th, 2003 03:59 AM |
| Soft Plastics hard or soft? | Chuck Coger | Bass Fishing | 6 | October 21st, 2003 01:31 PM |
Threaded Mode