![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
![]()
"Calif Bill" wrote in message
ink.net... Took off to Lake Oroville for the last camping trip of the year. About 90 degrees during the day and windy at night. Caught one 10" bass! Had on a couple of decent fish on a CR'ed baby brush hog. How can a fish, pull the worm and hard at that for 15' and never even expose the hook. Figured they must have been biting short and just pulling on the tail. Left my spinnerbait box at home and only had a 3/8 oz in the boat. needed a 3/4oz minimum as the fish were 25-35' deep. Only time I have failed dropshotting at Oroville. Never got a hit. Broke one pole. One of my downrigger poles for trout. A Shakespeare graphite. Looked at it's twin and there are splits in the middle of that one also. Went by Wally world Saturday evening to get batteries for the flashlight. Looked at getting a pole there for downrigging on Sunday for trout and salmon. 98% of the rods were spinning rods. The tackle store I normally use in Oroville was closed by the time we got off the lake. But you'd think that a fishing supply store in Oroville would carry at least 50% casting rods. Bill, you know that in a pinch a spinning rod is universal don't you? I have fished baitcasters and spincasters on spinning rods. in the past. If the action fits your fishing you can cope with the lack of a trigger for a couple days rather than lose out on some good fishing time. P.S. You never answered me about trading time on the water. Take me out on the Delta for a day, and I'll take you out on the Lower Colorado for a day. -- Bob La Londe Yuma, Az http://www.YumaBassMan.com Promote Your Fishing, Boating, or Guide Site for Free Simply add it to our index page. No reciprocal link required. (Requested, but not required) |
Thread Tools | |
Display Modes | |
|
|