|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
November 7th, 2003, 03:15 AM
|
|||
|
|||
spinning reel???
Thundercat has it right, Ken. Stradic 2500FH. Aluminum Frame and spool.
Steel, cut and polished gears, not aluminum cast. 4 sealed ball bearings and one roller bearing. Stradic reels deliver the goods over the long haul. The inexpensive reels are throwaways as far as I am concerned. Use them a couple of years, maybe, and get rid of them. Then go out and waste money again buying the same inexpensive throwaway reels again and again. I am not saying that the inexpensive reels are not good, I am saying buy it once for the long haul and save more money that way. The Stradic will not disappoint you. "kenneth blevins" wrote in message ... Hello group--- If you were going to buy a good spinning reel to go on a 7' MH rod what would your choice be.I have several lower end spinning reels and thought I'd spring for a better quality reel.Any suggestions and why Thanks for your time Ken Blevins 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loading new line onto spinning reel | Ian \(remove the antispam\) | General Discussion | 1 | June 22nd, 2004 12:52 AM |
| Reel fishermen | allen | General Discussion | 1 | April 17th, 2004 05:04 AM |
| spinning reel | Gone Angling | Bass Fishing | 9 | November 4th, 2003 09:51 PM |
| Diawa Spinning Reels/ Concern | Josh | Bass Fishing | 7 | September 24th, 2003 04:26 PM |
| Smallmouth Jig/Tube Spinning Rod/Reel | Rich Pierro | Bass Fishing | 0 | September 24th, 2003 02:47 PM |
Threaded Mode