|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
January 4th, 2005, 07:10 PM
|
|||
|
|||
Doh!!! I cannot believe I said gas dryer. I meant electric.
Jeff "Jeff Durham" wrote in message ... That is correct. If a trolling motor draws 30 amps at 12v for a certain thrust, a 24v system will only draw 15 amps for the same amount of thrust. This is hypothetical. In practice, it will be slightly different. That's the advantage of a gas dryer using 240 volts rather than 120 volts in that the amount of current will be half. Jeff "Todd Copeland" wrote in message nk.net... wrote in message news:a4GBd.57477$k25.3566@attbi_s53... A 24 volt system only uses half the current to do the same job as a 12 volt system, a 36 volt system uses 1/3 the current. So a 24 volt system only needs 12 volts to do the same job as a 12 volt sytem? Hmmm.... 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode