![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() Tried it, didn't like it |
#2
|
|||
|
|||
![]()
"Tom Nakashima" wrote in message
... I was wondering if anyone uses putty weight? Was thinking of going with split shots, but someone mentioned that I may want to try putty weight. Says he's never used it before, thought I better ask someone first before I purchase. -tom Several things: 1. In cold weather or after immersion in cold water it hardens; in hot weather it softens. So if you have a container of the stuff in your vest in the summer, it will flow down and seal itself to the lid of the container. You'll need a strong knife, screwdriver, or strong teeth to open it in cold weather. 2. I still have some of it on the roof of my car from when I laid my rigged rod on the roof while it was warm three years ago. 3. It's good to be able to use as much or as little as you want 4. I haven't had too many problems with it moving around on the line because I usually form it into an oblong ball with lots of surface on the line. Bob |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fly reel question | Mike | Fly Fishing | 32 | June 19th, 2004 05:27 PM |
Boat motor trailer weight? | Steve @ OutdoorFrontiers | Bass Fishing | 1 | February 26th, 2004 01:19 AM |
newby questions!! | katie star | Fly Fishing | 27 | January 5th, 2004 11:23 PM |
rod/line weight | Dan | Fly Fishing | 19 | January 2nd, 2004 04:44 PM |