|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 20th, 2003, 03:07 AM
|
|||
|
|||
Reels
Anybody else here built any reels? Specifically, I would like some info
about machining titanium alloy. Will "standard" ceramic cutters be OK? Cutting speeds? I have been given some titanium alloy pieces, and I donīt want to waste any of it. Also, I would be most interested if anybody has any info on making carbon fibre reels. TL MC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front Drag Reels | Jack Schmitt | Bass Fishing | 0 | June 13th, 2004 06:37 PM |
| adg fly rods and reels?? | steve sullivan | General Discussion | 24 | March 26th, 2004 06:27 AM |
| adg fly rods and reels?? | steve sullivan | Fly Fishing | 26 | March 26th, 2004 06:27 AM |
| ot casting reels | Gone Angling | Bass Fishing | 22 | January 3rd, 2004 06:45 AM |
| Who Are The Guru's of Reels | Craig | Bass Fishing | 6 | January 1st, 2004 10:10 AM |
Threaded Mode