If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Best knot for Power Pro tied to a crank bait?
What is the best knot for Power Pro when tied to a crank bait? I really like
the rapala knot, but I don't think it will hold with Power Pro. I have experimented by slightly modifying a Uni Knot (my favorite knot,especially for Power Pro). I first knot the line about 8" from the end. Just a simple knot. Then I pull the line through the crank bait so the knot goes through. Then I capture the knot under my thumb, make the loop, pass the tag through 8 times, wet the mess, then tighten up the Uni knot really tight before sliding it down to the bait. When I slide the Unit knot towards the bait it stops at the simple knot I tied leaving a nice loop like a rapala knot. Anyone ever try this? What do you do? |
Thread Tools | |
Display Modes | |
|
|