|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 14th, 2004, 06:38 PM
|
|||
|
|||
CRABBY CUTTER Where to Find
|
|
#2
April 14th, 2004, 07:06 PM
|
|||
|
|||
|
CRABBY CUTTER Where to Find
"Brad Bohrer" schrieb im Newsbeitrag ... CRABBY CUTTER can be found at www.dougsgear.com Take care, Brad Nine dollars for a seam ripper which costs a dollar in any sewing shop is a bit much! Also the pictures on your site are massive, even the thumbnails are 500kb it took ten minutes to download them on dual channel ISDN! I did not bother even trying to laod the enlargements. If you want to use one of these things, then I can think of better ways of doing so than fixing it to the vice post. Apart from which, palmed scissors, or a single edged razor blade are better. TL MC
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| find a fishing buddy | Allen | General Discussion | 1 | December 31st, 2004 01:19 PM |
| Do you need to find a pattern to be successful? | Craig Baugher | Bass Fishing | 2 | May 18th, 2004 02:51 AM |
| Testimonial reguarding CRABBY CUTTER | Brad Bohrer | Fly Fishing Tying | 4 | April 16th, 2004 09:09 AM |
| Fly Tying Cutter | Doug Breault | Fly Fishing Tying | 3 | March 21st, 2004 06:25 PM |
| some may find this interesting... | mgold | General Discussion | 0 | October 22nd, 2003 05:42 PM |
Linear Mode
